logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • When a line is loaded the characteristic impedance is equal to


  • Options
  • A. (R + j?L)(G + j?C)
  • B. When a line is loaded the characteristic impedance is equal to (R + j?L)(G + j?C) LC or .
  • C. When a line is loaded the characteristic impedance is equal to (R + j?L)(G + j?C) LC or .
  • D. LC

  • Correct Answer
  •  

    Explanation
    When a line is loaded the characteristic impedance is equal to (R + j?L)(G + j?C) LC or . or When a line is loaded the characteristic impedance is equal to (R + j?L)(G + j?C) LC or . When a line is loaded the characteristic impedance is equal to (R + j?L)(G + j?C) LC or ..

    Microwave Communication problems


    Search Results


    • 1. Consider the following applications

      1. TV tuning
      2. Active filter
      3. Microwave frequency multiplication
      In which of above can a varactor diode be used?

    • Options
    • A. 1 2 and 3
    • B. l and 2 only
    • C. 1 and 3 only
    • D. 2 and 3 only
    • Discuss
    • 2. A klystron amplifier generally uses Pierce gun

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

      Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 4. A pulsed radar produces 1 ? sec pulses at a rate of 1000 per second. The duty cycle is

    • Options
    • A. 0.001
    • B. 0.01
    • C. 0.1
    • D. 1
    • Discuss
    • 5. The component in the given figure is

    • Options
    • A. attenuator
    • B. T type low pass filter
    • C. T type high pass filter
    • D. phase shifter
    • Discuss
    • 6. If a line having Z0 = 300 ? 0 W is short circuited at far end, VSWR is

    • Options
    • A. 0 
    • B. 1
    • C. ?
    • D. 2
    • Discuss
    • 7. A reflex klystron oscillator uses

    • Options
    • A. one cavity resonator
    • B. two cavity resonators
    • C. three cavity resonators
    • D. none of the above
    • Discuss
    • 8. Ga As exhibits negative differential mobility

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. Microwave links are typically 50 km apart

    • Options
    • A. because of atmospheric attenuation
    • B. because of output tube power limitation
    • C. because of earth's curvature
    • D. to ensure that applied dc voltage is not excessive
    • Discuss
    • 10. If antenna diameter is increased four times, the maximum range is increased by a factor of

    • Options
    • A. 2
    • B. 2
    • C. 4
    • D. 0.2
    • Discuss


    Comments

    There are no comments.

Enter a new Comment