logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • Which of the following is wrong for a magic used to tee?


  • Options
  • A. E and H arms are decoupled
  • B. coplanar arms are coupled
  • C. all ports are perfectly matched
  • D. A signal into coplanar arm splits equally between E and H arms

  • Correct Answer
  • coplanar arms are coupled 

    Explanation
    Coplanar arms are decoupled.

    Microwave Communication problems


    Search Results


    • 1. Roughly the time required for microwave cooking as compared to conventional cooking is

    • Options
    • A. about twice
    • B. about half
    • C. about 10 times
    • D. about one-tenth
    • Discuss
    • 2. Consider the following applications

      1. Switch
      2. Attenuator
      3. Phase shifter
      4. Oscillator
      In which of the above can a PIN diode be used?

    • Options
    • A. 1 2 3 and 4
    • B. 1 2 and 3 only
    • C. 1 and 2 only
    • D. 2, 3 and 4 only
    • Discuss
    • 3. Assertion (A): PIN diode is used as a fast switch.

      Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 4. If a line is open circuited Zin = Z0 tanh (gl).

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. In a microwave coaxial line, the maximum operating frequency is f max and breakdown strength of dielectric is Ed' Then maximum power handling capacity is proportional to

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. The component in the given figure is

    • Options
    • A. attenuator
    • B. T type low pass filter
    • C. T type high pass filter
    • D. phase shifter
    • Discuss
    • 7. A pulsed radar produces 1 ? sec pulses at a rate of 1000 per second. The duty cycle is

    • Options
    • A. 0.001
    • B. 0.01
    • C. 0.1
    • D. 1
    • Discuss
    • 8. Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

      Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 9. A klystron amplifier generally uses Pierce gun

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. Consider the following applications

      1. TV tuning
      2. Active filter
      3. Microwave frequency multiplication
      In which of above can a varactor diode be used?

    • Options
    • A. 1 2 and 3
    • B. l and 2 only
    • C. 1 and 3 only
    • D. 2 and 3 only
    • Discuss


    Comments

    There are no comments.

Enter a new Comment