logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • If a line having Z0 = 300 ? 0 W is open circuited at far end, VSWR is


  • Options
  • A. 0
  • B. 1
  • C. ?
  • D. 2

  • Correct Answer


  • Explanation
    If line is o.c. |rv| = 1 and VSWR If a line having Z0 = 300 ? 0 W is open circuited at far end, VSWR is 0 1 ? 2 If line is o.c. |rv| = = ?.

    Microwave Communication problems


    Search Results


    • 1. The main feature of a parametric amplifier is

    • Options
    • A. low noise
    • B. very high gain
    • C. broad bandwidth
    • D. both (b) and (c)
    • Discuss
    • 2. In microwave system the function of mode filter is

    • Options
    • A. to suppress modes with lower cut off frequencies
    • B. to suppress modes with higher cut off frequencies
    • C. to change mode of wave transmission
    • D. both (b) and (c)
    • Discuss
    • 3. The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about

    • Options
    • A. 100°
    • B. 50°
    • C. 5°
    • D. 2°
    • Discuss
    • 4. A balun should have

    • Options
    • A. low SWR at both ports
    • B. high SWR at both ports
    • C. high SWR at input port and low SWR at output port
    • D. low SWR at input port and high SWR at output
    • Discuss
    • 5. Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z0?

    • Options
    • A. line open circuited at far end
    • B. line terminated in Z0
    • C. line short circuited at far end
    • D. line terminated in inductance
    • Discuss
    • 6. Which one of the following is transferred locking electron device C antenna?

    • Options
    • A. BARITT diode
    • B. IMPATT diode
    • C. Gunn diode
    • D. Step recovery diode
    • Discuss
    • 7. The directive gain of a transmitting antenna is proportional to

    • Options
    • A. its cross-sectional area
    • B. square of cross-sectional area
    • C. square root of cross-sectional area
    • D. cube root of cross-sectional area
    • Discuss
    • 8. A magnetron requires an external magnetic field with flux lines parallel to axis of cathode

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. High speed logic circuits use

    • Options
    • A. pulses with very small width
    • B. pulses with very large width
    • C. pulses whose width is neither small nor large
    • D. either (b) or (c)
    • Discuss
    • 10. The total field developed by an antenna array at a distant point is

    • Options
    • A. phasor sum of fields produced by individual antennas of the array
    • B. algebraic sum of fields produced by individual antennas of the array
    • C. either (a) or (b) depending on type of array
    • D. neither (a) nor (b)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment