The condition for underdamped oscillations in a series RLC circuit is

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
The condition for underdamped oscillations in a series RLC circuit is
Options
A.
B.
C.
D.

Correct Answer

Power Electronics problems

Search Results

1. A fully controlled bridge converter is feeding an RLE load. The load current is I₀. The input voltage is V_m sin ?t. The KVL equation to find firing angle a is
Options
A. cos a = E + I₀R
B. cos a = E + I₀R
C. cos a = E - I₀R
D. cos a = E - I₀R

2. The method of triggering SCS is
Options
A. application of positive pulse at cathode gate or negative pulse at anode gate
B. application of pulse at anode gate
C. application of pulse at cathode gate
D. application of low voltage at anode

3. In a full bridge circuit supplying an RLC under damped circuit
Options
A. the waveshapes of output voltage and load current are square
B. the waveshapes of output voltage and load current are sinusoidal
C. the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
D. none of the above

4. In a single phase cycloconverter with centre tapped transformer
Options
A. all thyristors carry currents for equal duration
B. the durations of currents in all thyristors may or may not be equal
C. the durations of currents in all thyristors cannot be equal
D. the duration of currents in all thyristors must be equal for satisfactory operation

6. When thyristors are connected in parallel, the current distribution may become non-uniform due to
Options
A. inductive effect of current carrying conductors
B. capacitive effect of current carrying conductors
C. both inductive and capacitive effects
D. none of the above

7. In a bridge inverter with single pulse width modulation
Options
A. the output frequency is equal to frequency of reference signal
B. the output frequency is equal to frequency of control signal
C. either (a) or (b)
D. neither (a) nor (b)

8. For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is for
Options
A. output voltage
B. input voltage
C. voltage drop across thyristor
D. none of the above

10. A LASCR has
Options
A. 4 semiconductor layers and 3 junctions
B. 3 semiconductor layers and 2 junctions
C. 2 semiconductor layers and 2 junctions
D. any of these depending on the rating

Comments

More in Electronics and Communication Engineering: