logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments
  • Question

  • As compared to a p-n junction diode


  • Options
  • A. a schottky diode has lower cut in voltage and lower reverse saturation current
  • B. a schottky diode has higher cut in voltage and higher reverse saturation current
  • C. a Schottky diode has lower cut in voltage and higher reverse saturation current
  • D. a schottky diode has higher cut in voltage and lower reverse saturation current

  • Correct Answer
  • a Schottky diode has lower cut in voltage and higher reverse saturation current 

    • Power Electronics problems

    Search Results

    • 1. In disc mounting of SCR

    • Options
    • A. SCR is clamped on one side of disc shaped heat sink
    • B. SCR is clamped between two disc shaped heat sinks
    • C. The SCR has low current rating
    • D. None of the above
      • Discuss
    • 2. When a single phase dual converter is operating in circulating current mode

    • Options
    • A. both converters are working as rectifiers simultaneously
    • B. one converter is always working as rectifier and the other as inverter
    • C. only one converter is working at one time
    • D. both converters are either working as rectifiers or as inverters simultaneously
      • Discuss
    • 3. The load circuit of a single phase full bridge inverter

    • Options
    • A. must be underdamped
    • B. must be overdamped
    • C. may be underdamped or overdamped
    • D. may be any type of load
      • Discuss
    • 4. Forward rating of an SCR is

    • Options
    • A. the maximum rate of rise of anode voltage which will trigger the SCR
    • B. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is applied
    • C. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is not applied
    • D. either (b) or (c)
      • Discuss
    • 5. The total number of leads in SCR, DIAC and TRIAC respectively are

    • Options
    • A. 3, 2, 3
    • B. 2, 3, 3
    • C. 3, 3, 2
    • D. 3, 2, 4
      • Discuss
    • 6. Which of the following is correct for a BJT?

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 7. Thyristors can be used for control of

    • Options
    • A. dc separately excited motor
    • B. dc shunt motor
    • C. dc series motor
    • D. all of the above
      • Discuss
    • 8. Assertion (A): A class C chopper can operate in first and second quadrants

      Reason (R): A class B chopper operates only in second quadrant.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
      • Discuss
    • 9. If Ar and Ac are the amplitudes of reference and control signals, the modulation index M is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 10. A single phase dual converter consists of

    • Options
    • A. two fully controlled converters connected in parallel
    • B. two fully controlled converters connected in antiparallel
    • C. two fully controlled semiconverters connected in antiparallel
    • D. two fully controlled semiconverters connected in parallel
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.