In disc mounting of SCR SCR is clamped on one side of disc shaped heat sink SCR

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
In disc mounting of SCR
Options
A. SCR is clamped on one side of disc shaped heat sink
B. SCR is clamped between two disc shaped heat sinks
C. The SCR has low current rating
D. None of the above

Correct Answer

SCR is clamped between two disc shaped heat sinks

Power Electronics problems

Search Results

1. When a single phase dual converter is operating in circulating current mode
Options
A. both converters are working as rectifiers simultaneously
B. one converter is always working as rectifier and the other as inverter
C. only one converter is working at one time
D. both converters are either working as rectifiers or as inverters simultaneously

3. Forward rating of an SCR is
Options
A. the maximum rate of rise of anode voltage which will trigger the SCR
B. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is applied
C. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is not applied
D. either (b) or (c)

6. As compared to a p-n junction diode
Options
A. a schottky diode has lower cut in voltage and lower reverse saturation current
B. a schottky diode has higher cut in voltage and higher reverse saturation current
C. a Schottky diode has lower cut in voltage and higher reverse saturation current
D. a schottky diode has higher cut in voltage and lower reverse saturation current

9. Assertion (A): A class C chopper can operate in first and second quadrants
Reason (R): A class B chopper operates only in second quadrant.
Options
A. Both A and R are correct and R is correct explanation of A
B. Both A and R correct but R is not correct explanation of A
C. A is correct but R is wrong
D. A is wrong but R is correct

Comments

More in Electronics and Communication Engineering: