Discussion
Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments
- Question
In a dual converter operated in circulating current mode, the circulating current flows
Options- A. when load current is zero
- B. when load current is non-zero
- C. even when load current is zero
- D. none of the above
- Correct Answer
- even when load current is zero
- 1. The snubber circuit consists of
Options- A. a capacitor connected in series with thyristor
- B. a capacitor connected in parallel with thyristor
- C. a resistor and capacitor in series connected across thyristor
- D. none of the above Discuss
- 2. In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
Options- A. 1
- B. 2
- C. 3
- D. 4 Discuss
- 3. The number of thyristors in a single phase fully controlled bridge rectifier is
Options- A. 16
- B. 8
- C. 4
- D. 2 Discuss
- 4. From which instant is the turn off time of a thyristor defined
Options- A. when anode voltage becomes zero
- B. when anode current becomes zero
- C. when both anode voltage and current become zero
- D. none of the above Discuss
- 5. When an SCR is reverse biased
Options- A. two junctions are reverse biased and one junction is forward biased.
- B. all the three junctions are reverse biased.
- C. one junction is reverse biased and two junctions are forward biased.
- D. any of the above depending on the magnitude of reverse bias. Discuss
- 6. Assertion (A): Light triggering is very suitable for HVDC transmission.
Reason (R): Light triggering has the advantage of complete electrical isolation of gate circuit.
Options- A. Both A and R are correct and R is correct explanation of A
- B. Both A and R correct but R is not correct explanation of A
- C. A is correct but R is wrong
- D. A is wrong but R is correct Discuss
- 7. In Jone chopper, the commutating element
Options- A. is a capacitor
- B. is a capacitor and an inductor
- C. is a capacitor and an auto transformer
- D. none of the above Discuss
- 8. The total number of leads in SCR, DIAC and TRIAC respectively are
Options- A. 3, 2, 3
- B. 2, 3, 3
- C. 3, 3, 2
- D. 3, 2, 4 Discuss
- 9. Forward
rating of an SCR is
Options- A. the maximum rate of rise of anode voltage which will trigger the SCR
- B. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is applied
- C. the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is not applied
- D. either (b) or (c) Discuss
- 10. The load circuit of a single phase full bridge inverter
Options- A. must be underdamped
- B. must be overdamped
- C. may be underdamped or overdamped
- D. may be any type of load Discuss
Power Electronics problems
Search Results
Correct Answer: a resistor and capacitor in series connected across thyristor
Correct Answer: 2
Correct Answer: 4
Correct Answer: when anode current becomes zero
Correct Answer: two junctions are reverse biased and one junction is forward biased.
Correct Answer: Both A and R are correct and R is correct explanation of A
Correct Answer: is a capacitor and an auto transformer
Correct Answer: 3, 2, 3
Correct Answer: the maximum rate of rise of anode voltage which will not trigger the SCR if gate signal is not applied
Correct Answer: may be any type of load
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.