logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • Multiphase choppers are used in


  • Options
  • A. low power circuits
  • B. high power circuit
  • C. both low and high power circuits
  • D. medium power circuits

  • Correct Answer
  • high power circuit 


  • Power Electronics problems


    Search Results


    • 1. A string of series connected thyristors needs equalising circuit to

    • Options
    • A. ensure proper firing
    • B. ensure proper current division
    • C. ensure proper voltage division
    • D. none of the above
    • Discuss
    • 2. In a single phase full wave ac regulator the firing angles during both half cycles are equal.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. A step up chopper can give an output voltage

    • Options
    • A. higher than input voltage
    • B. lower than input voltage
    • C. both higher and lower input voltage
    • D. all of the above
    • Discuss
    • 4. Assertion (A): A DIAC has four layers but only two terminals.

      Reason (R): A DIAC can conduct in both directions.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 5. A dc chopper is feeding an RLE load. The condition for maximum ripple is

    • Options
    • A. a = 1
    • B. a = 0.8
    • C. a = 0.5
    • D. a < 0.5
    • Discuss
    • 6. In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is

    • Options
    • A. 150 A
    • B. 75 A
    • C. 50 A
    • D. 300 A
    • Discuss
    • 7. A half bridge inverter

    • Options
    • A. needs a 3 wire dc supply
    • B. may use a two wire or 3 wire dc supply
    • C. has higher output voltage if fed from 3 wire dc supply
    • D. has higher efficiency if fed from 3 wire dc supply
    • Discuss
    • 8. A 3 phase series inverter has

    • Options
    • A. 12 thyristors
    • B. 6 thyristors
    • C. 3 thyristors
    • D. 3 or 6 thyristors
    • Discuss
    • 9. In a single phase converter using a centre tapped transformer and with a highly inductive load, the firing angles is a. Each thyristor conducts for a period

    • Options
    • A. p
    • B. a
    • C. p - a
    • D.
    • Discuss
    • 10. The symbol in figure is for

    • Options
    • A. UJT
    • B. PUT
    • C. SCS
    • D. SBS
    • Discuss


    Comments

    There are no comments.

Enter a new Comment