In a series inverter the commutating elements L and C are in parallel the commut

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
In a series inverter
Options
A. the commutating elements L and C are in parallel
B. the commutating elements L and C are in series with load
C. the commutating L and C may be in series or parallel with the load
D. none of the above

Correct Answer

the commutating elements L and C are in series with load

Power Electronics problems

Search Results

1. Which inverter circuit uses coupled inductors?
Options
A. Modified McMurray full bridge inverter
B. McMurray Bedford half bridge inverter
C. Modified McMurray Bedford half bridge inverter
D. Both (b) and (c)

2. In a 3 phase full converter, the instantaneous output voltage can have negative part if
Options
A. firing angle is less than 60�
B. firing angle is less than 90�
C. firing angle is more than 60�
D. firing angle is more than 90�

4. In thermal ohm's law, temperature and power loss are analogous to
Options
A. V and I respectively of ohm's law
B. I and V respectively of ohm's law
C. R and V respectively of ohm's law
D. I and R respectively of ohm's law

6. If the frequency is less than the damped frequency in a series- inverter
Options
A. the distortion of output voltage waveform is low
B. the distortion of output voltage waveform is high
C. the distortion of output voltage may be high or low depending on the load impedance
D. none of the above

8. A 3 phase dual converter consists of
Options
A. two 3 phase semiconverters connected in parallel
B. two 3 phase semiconverters connected in antiparallel
C. two 3 phase full converters connected in antiparallel
D. two 3 phase full converters connected in parallel

9. Surge current rating of an SCR is
Options
A. the maximum repetitive surge current in which the SCR can withstand
B. the maximum non-repetitive surge current in which the SCR can withstand
C. the maximum repetitive or non repetitive surge current in which the SCR can withstand
D. the maximum surge current in which the SCR can withstand if both surge current and steady current exist together

10. A surge voltage
Options
A. has very high magnitude and very long duration
B. has very high magnitude and very small duration
C. has very high magnitude and very small duration and can be positive or negative
D. can be only positive

Comments

More in Electronics and Communication Engineering: