Discussion
Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments
- Question
A single phase cycloconverter feeds a resistance heating load. The heating power is provided by
Options- A. only the fundamental component of output wave
- B. only higher harmonics in the output wave
- C. both fundamental and higher harmonics in the output wave
- D. either (a) or (b)
- Correct Answer
- both fundamental and higher harmonics in the output wave
- 1. In a thyristors are i = kva. The value of a is
Options- A. about 0.5
- B. about 2
- C. about 5
- D. about 20 Discuss
- 2. In a 3 phase bridge inverter with 180° mode of operation the numbers of thyristors conducting at one time are
Options- A. 1
- B. 2
- C. 3
- D. 4 Discuss
- 3. A single phase half wave rectifier circuit has a free wheeling diode. The free wheeling diode will conduct only if
Options- A. load is purely resistive
- B. load is purely inductive
- C. load is combination of R and L
- D. load is purely inductive or combination of R and L Discuss
- 4. A voltage VBB is applied across the terminals of a UJT. The emitter voltage at peak point is
Options- A. hVBB
- B. (h + 1) VBB
- C. hVBB + VD
- D. VD Discuss
- 5. In an ordinary thyristor
Options- A. turn on and turn off times are equal
- B. turn on time is more than turn off time
- C. turn off time is more than turn on time
- D. turn on time may be equal, less than or more than turn off time Discuss
- 6. A full bridge inverter is fed by a battery of 30 V. The rms value of output voltage is
Options- A. 15 V
- B. 152 V
- C. 30 V
- D. 302 V Discuss
- 7. Which of the following devices exhibit negative resistance characteristics?
Options- A. UJT
- B. PUT
- C. Both UJT and PUT
- D. UJT, PUT and SBS Discuss
- 8. Natural commutation can be used in :
Options- A. DC circuits only
- B. AC circuits only
- C. both AC and DC circuits
- D. none of the above Discuss
- 9. The gate lead, in a thyristor is welded to :
Options- A. p layer to which anode is connected
- B. n layer nearest to the anode terminal
- C. p layer nearest to the cathode terminal
- D. outside n layer Discuss
- 10. Which chopper circuit operates in all the 4 quadrants?
Options- A. A
- B. C
- C. D
- D. E Discuss
Power Electronics problems
Search Results
Correct Answer: about 5
Correct Answer: 3
Correct Answer: load is purely inductive or combination of R and L
Correct Answer: hVBB + VD
Correct Answer: turn off time is more than turn on time
Correct Answer: 30 V
Correct Answer: Both UJT and PUT
Correct Answer: AC circuits only
Correct Answer: n layer nearest to the anode terminal
Correct Answer: E
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.