logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • A voltage VBB is applied across the terminals of a UJT. The emitter voltage at peak point is


  • Options
  • A. hVBB
  • B. (h + 1) VBB
  • C. hVBB + VD
  • D. VD

  • Correct Answer
  • hVBB + VD 


  • Power Electronics problems


    Search Results


    • 1. In an ordinary thyristor

    • Options
    • A. turn on and turn off times are equal
    • B. turn on time is more than turn off time
    • C. turn off time is more than turn on time
    • D. turn on time may be equal, less than or more than turn off time
    • Discuss
    • 2. A 3 phase fully controlled bridge converter is fed by a 3 phase system having phase voltage v = Vm sin ?t. The firing angle is a. The dc output voltage is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. In the basic series inverter circuit, the source supplies load

    • Options
    • A. only in positive half cycle
    • B. both in positive and negative half cycles
    • C. only in part of positive half cycle
    • D. in positive half cycle and part of negative half cycle
    • Discuss
    • 4. In a full bridge inverter, the waveshape of load current depends on

    • Options
    • A. relative values of load parameters R, L and C
    • B. relative values of load parameters R and L
    • C. relative values of load parameters L and C
    • D. gating frequency
    • Discuss
    • 5. A current source inverter has simple commutation circuit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. A single phase half wave rectifier circuit has a free wheeling diode. The free wheeling diode will conduct only if

    • Options
    • A. load is purely resistive
    • B. load is purely inductive
    • C. load is combination of R and L
    • D. load is purely inductive or combination of R and L
    • Discuss
    • 7. In a 3 phase bridge inverter with 180° mode of operation the numbers of thyristors conducting at one time are

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
    • Discuss
    • 8. In a thyristors are i = kva. The value of a is

    • Options
    • A. about 0.5
    • B. about 2
    • C. about 5
    • D. about 20
    • Discuss
    • 9. A single phase cycloconverter feeds a resistance heating load. The heating power is provided by

    • Options
    • A. only the fundamental component of output wave
    • B. only higher harmonics in the output wave
    • C. both fundamental and higher harmonics in the output wave
    • D. either (a) or (b)
    • Discuss
    • 10. A full bridge inverter is fed by a battery of 30 V. The rms value of output voltage is

    • Options
    • A. 15 V
    • B. 152 V
    • C. 30 V
    • D. 302 V
    • Discuss


    Comments

    There are no comments.

Enter a new Comment