logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • As regards single phase dual converter


  • Options
  • A. the change in operation from one quadrant to the other is faster in non-circulating current mode
  • B. the change in operation from one quadrant to the other is faster in circulating current mode
  • C. the time response to change in operation from one quadrant to other is the same in both the modes
  • D. the time response to change in operation from one quadrant to the other may be faster in any of the two modes

  • Correct Answer
  • the change in operation from one quadrant to the other is faster in circulating current mode 


  • Power Electronics problems


    Search Results


    • 1. A Shockley diode can be used

    • Options
    • A. in place of SCR
    • B. as a trigger switch for SCR
    • C. in place of UJT
    • D. both in place of SCR and as a trigger switch for SCR
    • Discuss
    • 2. A single phase full converter gives maximum and minimum output voltage at firing angles of

    • Options
    • A. 0 and 180° respectively
    • B. 180° and 0° respectively
    • C. 0 and 90° respectively
    • D. 90° and 0° respectively
    • Discuss
    • 3. In controlled heating circuits, thyristors act as

    • Options
    • A. rectifier
    • B. inverter
    • C. ac regulator
    • D. chopper
    • Discuss
    • 4. On load tap changer using thyristors can have a maximum of two taps.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. In a single phase full bridge converter (B - 2 connection), the input voltage is v = Vm sin ?t. The output dc voltage for resistive load

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. In a parallel inverter

    • Options
    • A. the commutating capacitor C is across the primary of transformer and the load is across the secondary
    • B. the commutating capacitor and load are connected across the secondary of transformer
    • C. the commutating capacitor C and load are connected in series and the combination is across the secondary of transformer
    • D. none of the above
    • Discuss
    • 7. In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current

    • Options
    • A. are always similar
    • B. can never be similar
    • C. may be similar or dissimilar
    • D. are similar only if a = 0
    • Discuss
    • 8. Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

      Reason (R): Voltage across a capacitor can not change instantaneously.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 9. Which of these commutation methods is used in AC-DC converters?

    • Options
    • A. Class A
    • B. Class C
    • C. Class D
    • D. Class F
    • Discuss
    • 10. A silicon controlled switch has :

    • Options
    • A. 2 leads
    • B. 3 leads
    • C. 4 leads
    • D. 5 leads
    • Discuss


    Comments

    There are no comments.

Enter a new Comment