logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • In controlled heating circuits, thyristors act as


  • Options
  • A. rectifier
  • B. inverter
  • C. ac regulator
  • D. chopper

  • Correct Answer
  • ac regulator 

    Explanation
    The output voltage is controlled ac.

    Power Electronics problems


    Search Results


    • 1. On load tap changer using thyristors can have a maximum of two taps.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. In a single phase full bridge converter (B - 2 connection), the input voltage is v = Vm sin ?t. The output dc voltage for resistive load

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is

    • Options
    • A. 25% of maximum
    • B. 50% of maximum
    • C. 75% of maximum
    • D. none of the above
    • Discuss
    • 4. Present day HVDC converters are all

    • Options
    • A. 3 pulse converters
    • B. 6 pulse converters
    • C. 12 pulse converters
    • D. either 6 pulse or 12 converters
    • Discuss
    • 5. Assertion (A): A cycloconverter may be line commutated or forced commutated

      Reason (R): A step up cycloconverter requires forced commutation.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 6. A single phase full converter gives maximum and minimum output voltage at firing angles of

    • Options
    • A. 0 and 180° respectively
    • B. 180° and 0° respectively
    • C. 0 and 90° respectively
    • D. 90° and 0° respectively
    • Discuss
    • 7. A Shockley diode can be used

    • Options
    • A. in place of SCR
    • B. as a trigger switch for SCR
    • C. in place of UJT
    • D. both in place of SCR and as a trigger switch for SCR
    • Discuss
    • 8. As regards single phase dual converter

    • Options
    • A. the change in operation from one quadrant to the other is faster in non-circulating current mode
    • B. the change in operation from one quadrant to the other is faster in circulating current mode
    • C. the time response to change in operation from one quadrant to other is the same in both the modes
    • D. the time response to change in operation from one quadrant to the other may be faster in any of the two modes
    • Discuss
    • 9. In a parallel inverter

    • Options
    • A. the commutating capacitor C is across the primary of transformer and the load is across the secondary
    • B. the commutating capacitor and load are connected across the secondary of transformer
    • C. the commutating capacitor C and load are connected in series and the combination is across the secondary of transformer
    • D. none of the above
    • Discuss
    • 10. In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current

    • Options
    • A. are always similar
    • B. can never be similar
    • C. may be similar or dissimilar
    • D. are similar only if a = 0
    • Discuss


    Comments

    There are no comments.

Enter a new Comment