In the below figure the rms voltage across each half of secondary is 200 V. The

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
In the below figure the rms voltage across each half of secondary is 200 V. The peak inverse voltage across each of thyristor is
Options
A. 200 V
B. 2(200) V
C. 2(400) V
D. 800 V

Correct Answer

2(400) V

Explanation

PIV = 2(2 x 200).

Power Electronics problems

Search Results

1. A thyristor has its gate current zero. To start conduction the forward voltage must exceed
Options
A. about 0.5 V
B. forward breakover voltage
C. on state voltage
D. peak working off state forward voltage

2. A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
Options
A. V_m
B. 0.5 V_m
C. zero
D. 0.5 V_m - voltage drop across inductance

3. In a 3 phase semiconverter, the firing frequency is
Options
A. equal to line frequency
B. 3 times the line frequency
C. 6 times the line frequency
D. 12 times the line frequency

4. In dielectric heating, the thyristor circuits consist of
Options
A. rectifier-chopper combination
B. controlled rectifier
C. ac regulator
D. rectifier-inverter combination

5. In a multiphase chopper, the different choppers operate in
Options
A. series and all simultaneously
B. parallel and one at a time
C. parallel and simultaneously
D. either (b) or (c)

8. In an SCR, the anode current consists of
Options
A. only holes
B. only electrons
C. both electrons and holes
D. either electrons or holes

10. In a single phase dual converter, a₁, and a₂ are firing angles of the two converters. Then
Options
A. a₁ - a₂ =
B. a₁ + a₂ = p
C. a₁ - a₂ = p
D. a₁ + a₂ =

Comments

There are no comments.

More in Electronics and Communication Engineering: