Discussion
Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
- Question
In a transistor receiver, the use of FET as the first stage amplifier is likely to
Options- A. improve selectivity of the receiver
- B. improve the effectiveness of the AGC
- C. reduce the effect of negative peak clipping
- D. reduce the effect of noise at all frequencies
- Correct Answer
- reduce the effect of negative peak clipping
- 1. Three point tracking can be achieved with
Options- A. gang condenser
- B. variable selectivity
- C. paddar capacitor
- D. any of the above Discuss
- 2. Statement 1
Diode is the most common device used for demodulation.
Statement 2
A discriminator is a FM detector.
Options- A. Statement 1 is true but statement 2 is false
- B. Statement 1 is false but statement 2 is true
- C. Both the statements are true
- D. Both the statements are false Discuss
- 3. Vividh Bharati programme is transmitted in
Options- A. short wave
- B. medium frequency
- C. very high frequency
- D. all of the above Discuss
- 4. A low ratio of the A.C. load impedance of a diode detector results in
Options- A. diagonal clipping
- B. poor AGC operation
- C. poor AF response
- D. negative peak clipping Discuss
- 5. Superheterodyne receiver can be used in
Options- A. AM
- B. FM
- C. SSB
- D. All of the above Discuss
- 6. A padder is basically a/an
Options- A. insulator
- B. variable resistor
- C. capacitor
- D. inductor Discuss
- 7. FM receivers using the standard 88 to 108 MHz band use IF of
Options- A. 8 MHz
- B. 9.9 MHz
- C. 10.7 MHz
- D. 12.2 MHz Discuss
- 8. Power spectral density of white noise
Options- A. is constant with frequency
- B. increases with frequency
- C. decreases with frequency
- D. none Discuss
- 9. A FM signal with modulation index Mf is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
Options- A. Mf
- B. Mf/2
- C. 2Mf
- D. UMf Discuss
- 10. In a FM waveform, the side bands are spaced at intervals equal to
Options- A. four times the modulating frequency
- B. twice the modulating frequency
- C. half the modulating frequency
- D. modulating frequency Discuss
Radio Receivers problems
Search Results
Correct Answer: variable selectivity
Correct Answer: Both the statements are true
Correct Answer: medium frequency
Correct Answer: negative peak clipping
Correct Answer: All of the above
Correct Answer: inductor
Correct Answer: 10.7 MHz
Correct Answer: is constant with frequency
Correct Answer: 2Mf
Correct Answer: half the modulating frequency
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.