logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Radio Receivers Comments

  • Question
  • Three point tracking can be achieved with


  • Options
  • A. gang condenser
  • B. variable selectivity
  • C. paddar capacitor
  • D. any of the above

  • Correct Answer
  • variable selectivity 


  • Radio Receivers problems


    Search Results


    • 1. Statement 1
      Diode is the most common device used for demodulation.
      Statement 2
      A discriminator is a FM detector.

    • Options
    • A. Statement 1 is true but statement 2 is false
    • B. Statement 1 is false but statement 2 is true
    • C. Both the statements are true
    • D. Both the statements are false
    • Discuss
    • 2. Vividh Bharati programme is transmitted in

    • Options
    • A. short wave
    • B. medium frequency
    • C. very high frequency
    • D. all of the above
    • Discuss
    • 3. A low ratio of the A.C. load impedance of a diode detector results in

    • Options
    • A. diagonal clipping
    • B. poor AGC operation
    • C. poor AF response
    • D. negative peak clipping
    • Discuss
    • 4. Superheterodyne receiver can be used in

    • Options
    • A. AM
    • B. FM
    • C. SSB
    • D. All of the above
    • Discuss
    • 5. The household radio receiver uses

    • Options
    • A. synchronous
    • B. envelope detector
    • C. radio detector
    • D. none of the above
    • Discuss
    • 6. In a transistor receiver, the use of FET as the first stage amplifier is likely to

    • Options
    • A. improve selectivity of the receiver
    • B. improve the effectiveness of the AGC
    • C. reduce the effect of negative peak clipping
    • D. reduce the effect of noise at all frequencies
    • Discuss
    • 7. A padder is basically a/an

    • Options
    • A. insulator
    • B. variable resistor
    • C. capacitor
    • D. inductor
    • Discuss
    • 8. FM receivers using the standard 88 to 108 MHz band use IF of

    • Options
    • A. 8 MHz
    • B. 9.9 MHz
    • C. 10.7 MHz
    • D. 12.2 MHz
    • Discuss
    • 9. Power spectral density of white noise

    • Options
    • A. is constant with frequency
    • B. increases with frequency
    • C. decreases with frequency
    • D. none
    • Discuss
    • 10. A FM signal with modulation index Mf is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of

    • Options
    • A. Mf
    • B. Mf/2
    • C. 2Mf
    • D. UMf
    • Discuss


    Comments

    There are no comments.

Enter a new Comment