Discussion
Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
- Question
Statement 1
Diode is the most common device used for demodulation.
Statement 2
A discriminator is a FM detector.
Options- A. Statement 1 is true but statement 2 is false
- B. Statement 1 is false but statement 2 is true
- C. Both the statements are true
- D. Both the statements are false
- Correct Answer
- Both the statements are true
- 1. Vividh Bharati programme is transmitted in
Options- A. short wave
- B. medium frequency
- C. very high frequency
- D. all of the above Discuss
- 2. A low ratio of the A.C. load impedance of a diode detector results in
Options- A. diagonal clipping
- B. poor AGC operation
- C. poor AF response
- D. negative peak clipping Discuss
- 3. Superheterodyne receiver can be used in
Options- A. AM
- B. FM
- C. SSB
- D. All of the above Discuss
- 4. The household radio receiver uses
Options- A. synchronous
- B. envelope detector
- C. radio detector
- D. none of the above Discuss
- 5. Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
Options- A. IF stage
- B. RF stage
- C. power amplification stage
- D. none of the above Discuss
- 6. Three point tracking can be achieved with
Options- A. gang condenser
- B. variable selectivity
- C. paddar capacitor
- D. any of the above Discuss
- 7. In a transistor receiver, the use of FET as the first stage amplifier is likely to
Options- A. improve selectivity of the receiver
- B. improve the effectiveness of the AGC
- C. reduce the effect of negative peak clipping
- D. reduce the effect of noise at all frequencies Discuss
- 8. A padder is basically a/an
Options- A. insulator
- B. variable resistor
- C. capacitor
- D. inductor Discuss
- 9. FM receivers using the standard 88 to 108 MHz band use IF of
Options- A. 8 MHz
- B. 9.9 MHz
- C. 10.7 MHz
- D. 12.2 MHz Discuss
- 10. Power spectral density of white noise
Options- A. is constant with frequency
- B. increases with frequency
- C. decreases with frequency
- D. none Discuss
Radio Receivers problems
Search Results
Correct Answer: medium frequency
Correct Answer: negative peak clipping
Correct Answer: All of the above
Correct Answer: envelope detector
Correct Answer: IF stage
Correct Answer: variable selectivity
Correct Answer: reduce the effect of negative peak clipping
Correct Answer: inductor
Correct Answer: 10.7 MHz
Correct Answer: is constant with frequency
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.