logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
  • Question

  • The selectivity curve of a standard receiver is represented by
    The selectivity curve of a standard receiver is represented by curve A curve B curve C curve D


  • Options
  • A. curve A
  • B. curve B
  • C. curve C
  • D. curve D

  • Correct Answer
  • curve C 

    • Radio Receivers problems

    Search Results

    • 1. RF amplifiers are used in radio receivers for

    • Options
    • A. better sensitivity
    • B. improved signal-to-noise ratio
    • C. better coupling of receiver to the antenna
    • D. all of the above
      • Discuss
    • 2. When a superheterodyne receiver is tuned to 455 kHz, its local oscillator provides a mixer with the input at 1010 kHz. The image frequency is

    • Options
    • A. 555 kHz
    • B. 1010 kHz
    • C. 1465 kHz
    • D. 1920 kHz
      • Discuss
    • 3. Which of the following circuit cannot be used to demodulate SSB?

    • Options
    • A. Phase discriminator
    • B. Produce detector
    • C. Balanced modulator
    • D. Beat frequency oscillator
      • Discuss
    • 4. The passband of the tuned circuits of a radio receiver should be equal to

    • Options
    • A. 20 kHz
    • B. 455 kHz
    • C. 1455 kHz
    • D. more than 455 kHz
      • Discuss
    • 5. Which curve represents the fidelity curve of a standard receiver?

    • Options
    • A. Curve A
    • B. Curve B
    • C. Curve C
    • D. Curve D
      • Discuss
    • 6. In a receiver, which of the following device has RF input but IF output?

    • Options
    • A. Loudspeaker
    • B. Frequency changer
    • C. Demodulator
    • D. Audio amplifier
      • Discuss
    • 7. Fidelity of a receiver represents

    • Options
    • A. the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
    • B. the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
    • C. the variation of the output with the modulation frequency when the output impedance is a resistance
    • D. none of the above
      • Discuss
    • 8. A receiver having an RF amplifier and an IF of 450 kHz, has Q of the coils 65 and an incoming frequency of 1200 kHz. The image rejection of the receiver is

    • Options
    • A. 5870
    • B. 3655
    • C. 236
    • D. 13.3
      • Discuss
    • 9. The source of which of the following noise is different from that of the remaining?

    • Options
    • A. Solar noise
    • B. Cosmic noise
    • C. Galactic noise
    • D. Atmospheric noise
      • Discuss
    • 10. The sensitivity of a superheterodyne receiver is determined by

    • Options
    • A. the gain IF amplifier
    • B. the gain of RF amplifier
    • C. the noise figure
    • D. all of the above
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.