logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
  • Question

  • The passband of the tuned circuits of a radio receiver should be equal to


  • Options
  • A. 20 kHz
  • B. 455 kHz
  • C. 1455 kHz
  • D. more than 455 kHz

  • Correct Answer
  • 20 kHz 

    • Radio Receivers problems

    Search Results

    • 1. Which curve represents the fidelity curve of a standard receiver?

    • Options
    • A. Curve A
    • B. Curve B
    • C. Curve C
    • D. Curve D
      • Discuss
    • 2. Selectivity varies with receiving frequency, frequency is raised.

    • Options
    • A. Somewhat better when the receiving frequency is raised
    • B. Somewhat better at intermediate frequency
    • C. Somewhat worse when the receiving frequency is lowered
    • D. Somewhat worse when the receiving frequency is raised
      • Discuss
    • 3. Double spotting in a receiver is due to

    • Options
    • A. poor sensitivity of RF amplifier
    • B. high gain of IF amplifier
    • C. inadequate image frequency rejection
    • D. all of the above
      • Discuss
    • 4. Noise limiter is provided on AM receivers to

    • Options
    • A. reduce interfering noise due to ignition system
    • B. reduce noise due to electrical storms
    • C. reduce interference due to electrical machinery
    • D. all of the above
      • Discuss
    • 5. An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is

    • Options
    • A. AM-DSB signal with suppressed carrier
    • B. AM-DSB signal with carrier
    • C. AM-SSB signal with carrier
    • D. a sequence of exponentially decaying sine waves
      • Discuss
    • 6. Which of the following circuit cannot be used to demodulate SSB?

    • Options
    • A. Phase discriminator
    • B. Produce detector
    • C. Balanced modulator
    • D. Beat frequency oscillator
      • Discuss
    • 7. When a superheterodyne receiver is tuned to 455 kHz, its local oscillator provides a mixer with the input at 1010 kHz. The image frequency is

    • Options
    • A. 555 kHz
    • B. 1010 kHz
    • C. 1465 kHz
    • D. 1920 kHz
      • Discuss
    • 8. RF amplifiers are used in radio receivers for

    • Options
    • A. better sensitivity
    • B. improved signal-to-noise ratio
    • C. better coupling of receiver to the antenna
    • D. all of the above
      • Discuss
    • 9. The selectivity curve of a standard receiver is represented by

    • Options
    • A. curve A
    • B. curve B
    • C. curve C
    • D. curve D
      • Discuss
    • 10. In a receiver, which of the following device has RF input but IF output?

    • Options
    • A. Loudspeaker
    • B. Frequency changer
    • C. Demodulator
    • D. Audio amplifier
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.