logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Radio Receivers See What Others Are Saying!
  • Question
  • In a radio receiver


  • Options
  • A. the local oscillator frequency is made higher than the incoming signal frequency
  • B. the local oscillator frequency is made lower than the incoming signal frequency
  • C. the local oscillator frequency is made equal to the incoming signal frequency

  • Correct Answer
  • the local oscillator frequency is made higher than the incoming signal frequency 


  • More questions

    • 1. VTM stands for voltage tunable magnetron.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. In a step down chopper using pulse width modulation, Ton = 3 x 10-3 and Toff = 1 x 10-3 s. The chopping frequency is

    • Options
    • A. 333.33
    • B. 250
    • C. 500
    • D. 1000
    • Discuss
    • 3. Non-coherently detection is not possible for

    • Options
    • A. PSK
    • B. ASK
    • C. FSK
    • D. both (a) and (c)
    • Discuss
    • 4. Match the following:

      List I List II
      A. Wein bridge oscillator 1. Low output impedance
      B. Voltage shunt feedback amplifier 2. RF frequency range
      C. Crystal oscillator 3. Audio frequency range
      D. Current shunt feedback amplifier 4. High input impedance
      5. High output impedance


    • Options
    • A. A-3, B-1, C-2, D-5
    • B. A-3, B-5, C-1, D-2
    • C. A-4, B-3, C-1, D-2
    • D. A-5, B-1, C-2, D-1
    • Discuss
    • 5. For attenuation of high frequencies we should use

    • Options
    • A. shunt capacitance
    • B. series capacitance
    • C. inductance
    • D. resistance
    • Discuss
    • 6. In a high frequency coaxial line and the length of line characteristic impedance is a function of

    • Options
    • A. properties of insulating material only
    • B. inner and outer conductor radius only
    • C. both (a) and (b)
    • D. neither (a) nor (b)
    • Discuss
    • 7. As regards dielectric constant ?r

    • Options
    • A. the units are farads/m
    • B. the units are newton/coulomb
    • C. it is dimensionless
    • D. the units are farads
    • Discuss
    • 8. From which instant is the turn off time of a thyristor defined

    • Options
    • A. when anode voltage becomes zero
    • B. when anode current becomes zero
    • C. when both anode voltage and current become zero
    • D. none of the above
    • Discuss
    • 9. In a single phase full wave regulator, the rms current in each thyristors is Ir The run load current is equal to

    • Options
    • A. 2Ir
    • B. 2 Ir
    • C. Ir
    • D.
    • Discuss
    • 10. A disadvantage of microstrip line as the connections of compared to strip line is that former

    • Options
    • A. do not lend themselves to printed circuit
    • B. are more likely to radiate
    • C. are bulky
    • D. are more expensive and complex
    • Discuss


    Comments

    There are no comments.

Enter a new Comment