logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Radio Receivers Comments

  • Question
  • Which of the following noise becomes of great importance at high frequencies?


  • Options
  • A. Transit-time noise
  • B. Shot noise
  • C. Flicker noise
  • D. Agitation noise

  • Correct Answer
  • Transit-time noise 


  • Radio Receivers problems


    Search Results


    • 1. High IF in a superheat receiver

    • Options
    • A. improves selectivity
    • B. increases tracking problems
    • C. decreases tracking problems
    • D. reduces adjacent channel rejection
    • Discuss
    • 2. Which of the following statement about the advantage of phase discriminator over the slope detector is false?

    • Options
    • A. Fewer tuned circuits
    • B. Better linearity
    • C. Greater limiting
    • D. Much easier alignment
    • Discuss
    • 3. Assertion (A): Electron concentration n, hole concentration p and charge concentration ni are related by ni2 = np.

      Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.


    • Options
    • A. Both A and R are true and R is correct explanation of A
    • B. Both A and R are true but R is not correct explanation of A
    • C. A is true but R is false
    • D. A is false but R is true
    • Discuss
    • 4. As regards dielectric constant ?r

    • Options
    • A. the units are farads/m
    • B. the units are newton/coulomb
    • C. it is dimensionless
    • D. the units are farads
    • Discuss
    • 5. In ferromagnetic materials, the orientation between neighbouring permanent dipoles is parallel.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. The image frequency of a superheterodyne receiver is

    • Options
    • A. independent of the frequency at which the receiver is tuned
    • B. always outside the operating range of the receiver
    • C. typical to FM receivers only
    • D. not rejected by the IF tuned circuits
    • Discuss
    • 7. In a radio receiver

    • Options
    • A. the local oscillator frequency is made higher than the incoming signal frequency
    • B. the local oscillator frequency is made lower than the incoming signal frequency
    • C. the local oscillator frequency is made equal to the incoming signal frequency
    • Discuss
    • 8. In a receiver, at higher frequencies

    • Options
    • A. tracking will be improved
    • B. tracking will be poor
    • C. selectivity will be poor
    • D. image frequency rejection will be poor
    • Discuss
    • 9. The IF stage of a receiver employs

    • Options
    • A. capacitive coupling
    • B. impedance coupling
    • C. double-tuned transformer coupling
    • D. single-tuned transformer coupling
    • Discuss
    • 10. In an FM signal, the power

    • Options
    • A. increases as the modulation index increases
    • B. reduces as the modulation index increase
    • C. increases as the modulation index decreases
    • D. remains constant when the modulation index increases
    • Discuss


    Comments

    There are no comments.

Enter a new Comment