logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ GATE Exam Questions Comments
  • Question

  • The relationship between the length (l) and radius (r) of an ideal transition curve is given by


  • Options
  • A. l ? r
  • B. l ? r2
  • C. l ? 1/r
  • D. l ? 1/r2

  • Correct Answer
  • l ? 1/r 

    • GATE Exam Questions problems

    Search Results

    • 1. The shape of clay particle is usually

    • Options
    • A. angular
    • B. flaky
    • C. tubular
    • D. rounde
      • Discuss
    • 2. The type of surveying in which the curvature of the earth is taken into account is called

    • Options
    • A. Geodetic surveying
    • B. Plane surveying
    • C. Preliminary surveying
    • D. Topographical surveying
      • Discuss
    • 3. What is the equivalent single wheel load of a dual wheel assembly carrying 20, 440 N each for pavement thickness of 20 cm? Centre to centre spacing of tyres is 27 cm and the distance between the walls of tyres is 11 cm

    • Options
    • A. 27, 600 N
    • B. 32, 300 N
    • C. 40, 880 N
    • D. 30, 190 N
      • Discuss
    • 4. For a highway with design speed of 100 kmph, the safe overtaking sight distance is (assume accelerations as 0.53 m/sec2)

    • Options
    • A. 300 m
    • B. 750 m
    • C. 320 m
    • D. 470 m
      • Discuss
    • 5. The material that exhibits the same elastic properties in all the directions at a point, is said to be

    • Options
    • A. homogeneous
    • B. orthotropic
    • C. visco-elastic
    • D. isotropic
      • Discuss
    • 6. The group index of a soil subgrade is 7. The subgrade soil is rated as

    • Options
    • A. poor
    • B. very poor
    • C. good
    • D. fair
      • Discuss
    • 7. The width of expansion joint gap is 2.5 cm in a cement concrete pavement. The spacing between expansion joints for a maximum rise in temperature of 25°C is, (assuming coefficient of thermal expansion of concrete as 10 x 10-6 per degree C),

    • Options
    • A. 5 m
    • B. 50 m
    • C. 100 m
    • D. 25 M
      • Discuss
    • 8. The shape factor of the section shown in the below figure is

    • Options
    • A. 1.5
    • B. 1.12
    • C. 2
    • D. 1.7
      • Discuss
    • 9. If, for a fluid in motion, pressure at a point is same in all directions, then the fluid is :

    • Options
    • A. a real fluid
    • B. a Newtonian fluid
    • C. an ideal fluid
    • D. a non-Newtonian fluid
      • Discuss
    • 10. Sand drains are used to :

    • Options
    • A. reduce the settlement
    • B. accelerate the consolidation
    • C. increase the permeability
    • D. transfer the load
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.