logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ GATE Exam Questions Comments
  • Question

  • Bending moments at joint b and c of the portal frame are respectively :
    Bending moments at joint b and c of the portal frame are respectively : + p l/2, - p l/2 + p l/2, +


  • Options
  • A. + p l/2, - p l/2
  • B. + p l/2, + p l/2
  • C. + p l/4, - p l/4
  • D. + p l/4, + p l/4

  • Correct Answer
  • + p l/2, + p l/2 

    • GATE Exam Questions problems

    Search Results

    • 1. Generally (fatigue life of welded steel structure/fatigue life of riveted steel structure) ratio is,

    • Options
    • A. smaller than 1
    • B. equal to 1
    • C. greater than 1
    • D. greater than 2.1
      • Discuss
    • 2. In an area of 200 hectare, water table drops by 4 m. If the porosity is 0.35 and the specific retention is 0.15, change in volume of storage in the aquifer is

    • Options
    • A. 160 m3
    • B. 1.6 x 106 m
    • C. 8 x 106 m3
    • D. 1.6 x 103 m3
      • Discuss
    • 3. The Piezometric head at point C, in the experimental set-up shown in the below figure when the flow takes place under a constant head through the soils A and B is

    • Options
    • A. 0 cm
    • B. 40 cm
    • C. 80 cm
    • D. 120 cm
      • Discuss
    • 4. If a single pipe of length L and diameter D is to be replaced by three pipes of same material, same length and equal diameter d (d < D), to convey the same total discharge under the same head loss, then d and D are related by

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 5. The BOD removal efficiency, in percentage, during primary treatmet under normal conditions is about

    • Options
    • A. 65%
    • B. 85%
    • C. 30%
    • D. Zero
      • Discuss
    • 6. The effective width of a reinforced concrete T beam flange under compression, according to IS : 456-1978, given I0 is the distance between the adjacent zero moment points, b is the breadth of the rib and D is the thickness of the flange, is

    • Options
    • A.
    • B. I0 + 6D
    • C.
    • D.
      • Discuss
    • 7. Factor of safety adopted by IS : 800 - 1984 while arriving at the permissible stress in axial compression, is :

    • Options
    • A. 2.00
    • B. 1.00
    • C. 1.67
    • D. 1.50
      • Discuss
    • 8. In highway pavements emulsions are mainly used in :

    • Options
    • A. surface dressing
    • B. patching and maintenance operation
    • C. bitumen macadam
    • D. asphaltic concrete
      • Discuss
    • 9. A river 5 m deep consists of a sand bed with saturated unit weight of 20 kN/m3 . vw = 9.81 kN/m3. The effective vertical stress at 5 m from the top of sand bed is

    • Options
    • A. 41 kN/m2
    • B. 51 kN/m2
    • C. 55 kN/m2
    • D. 53 kN/m2
      • Discuss
    • 10. Storage coefficient of a compressible confined aquifer is a function of

    • Options
    • A. specific weight of water, thickness of the aquifer, compressibility of the aquifer and that of water
    • B. permeability, thickness and compressibility of aquifer and compressibility of water
    • C. transmissibility of the aquifer and compressibility of water
    • D. transmissibility of aquifer and specific yield of aquifer
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.