logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ GATE Exam Questions Comments
  • Question

  • The following two statements are made with reference to the planar truss shown below
    The following two statements are made with reference to the planar truss shown below The truss is st

    1. The truss is statically determinate
    2. The truss is kinematically determinate

    With refernece to the above statements, which of the following applies?


  • Options
  • A. Both statements are ture.
  • B. Both statements are false.
  • C. II is true but I false.
  • D. I is true but II is false.

  • Correct Answer
  • II is true but I false. 

    • GATE Exam Questions problems

    Search Results

    • 1. The standard plate size in a plate bearing test for finding modulus of subgrade reaction (k) value is

    • Options
    • A. 100 cm diameter.
    • B. 50 cm diameter.
    • C. 75 cm diameter.
    • D. 25 cm diameter.
      • Discuss
    • 2. The appropriate field test to determine the insitu undrained shear strength of soft clay is :

    • Options
    • A. plate load test
    • B. static cone penetration test
    • C. standard penetration test
    • D. vane shear test
      • Discuss
    • 3. Rapid curing cut back bitumen is produced by blending bitumen with

    • Options
    • A. Kerosene
    • B. Benzene
    • C. Diesel
    • D. Petrol
      • Discuss
    • 4. The settlement of prototype in granular material may be estimated using plate load test data from the following expression :

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 5. Water distribution systems are sized to meet the

    • Options
    • A. maximum hourly demand
    • B. average hourly demand
    • C. maximum daily demand and fire demand
    • D. average daily demand and fire demand.
      • Discuss
    • 6. The penetration test for bitumen is conduced at a temperature of

    • Options
    • A. 60°C
    • B. 37°C
    • C. 25°C
    • D. 50°C
      • Discuss
    • 7. The net effective cross sectional area calculated in the steel angle tension member design, accounts for:

    • Options
    • A. the tensile force and bolt holes
    • B. the eccentricity of the end connections and the bolt holes
    • C. the effectiveness of the tack connection along the length
    • D. the effectiveness of the end connection
      • Discuss
    • 8. The equation along a stream line holds true for :

    • Options
    • A. steady, frictionless, compressible fluid
    • B. steady, uniform, incompressible fluid
    • C. steady, frictionless, incompressible fluid
    • D. unsteady incompressible fluid
      • Discuss
    • 9. A three hinged arch shown in the below figur is quarter of a circle, If the vertical and horizontal components of reaction at A are equal, the value of ? is

    • Options
    • A. 60°
    • B. 45°
    • C. 30°
    • D. None in (0°, 90°)
      • Discuss
    • 10. The problem of lateral buckling can arise only in those steel beams which have

    • Options
    • A. Moment of inertia about the bending axis larger than the other
    • B. Moment of inertia about the bending axis smaller than the other
    • C. Fully supported compression flange
    • D. None of the above.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.