Discussion
Home ‣ Civil Engineering ‣ Structural Design Specifications Comments
- Question
The pitch of transverse reinforcement of a column is taken as
Options- A. least lateral diamension of the compression member
- B. sixteen times the smallest diameter of the longitudinal reinforcement of the column
- C. forty eight times the diameter of the transverse reinforcement
- D. least value of the above.
- Correct Answer
- least value of the above.
- 1. The ratio of the effective lengths of two columns, one effectively held in position at one end and partially restrained at the other end, and the other effectively held in position at one end and free at the other end, is
Options- A.
- B.
- C.
- D.
Discuss
- 2. For design purpose, the moment at the support where two unequal spans or spans not equally loaded meet, is
Options- A. lesser value
- B. greater value
- C. average of two values
- D. none of these. Discuss
- 3. Creep of concrete is assumed proportional to the stress if the stress does not exceed .......of the characteristic compressive strength
Options- A. 15%
- B. 20%
- C. 25%
- D. 33%
- E. 50% Discuss
- 4. The characteristic strength of concrete is the strength of material if its test result is not less than
Options- A. 2%
- B. 3%
- C. 4%
- D. 5%
- E. 10% Discuss
- 5. M 30 grade concrete means, its compressive strength of 15-cm cube, is 30 N/mm2 after
Options- A. 3 days
- B. 7 days
- C. 21 days
- D. 28 days Discuss
- 6. The maximum pitch of rivets for compression and tension members should not exceed
Options- A. 32 t
- B. 200 mm
- C. 40 t
- D. 300 mm
- E. both (a) and (d) Discuss
- 7. As per IS : 1982, the permissible axial tension in rolled I-beams and channels, is
Options- A. 1500 kg/cm2
- B. 1800 kg/cm2
- C. 1400 kg/cm2
- D. 1420 kg/cm2 Discuss
- 8. Minimum diameter of the lateral ties should not be less than
Options- A. 4 mm
- B. 5 mm
- C. 6 mm
- D. 10 mm Discuss
- 9. The tolerances for the form work of columns and beams range from
Options- A. - 3 mm to + 6 mm
- B. - 4 mm to + 8 mm
- C. - 6 mm to + 12 mm
- D. - 8 mm to + 12 mm Discuss
- 10. The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of
Options- A. 300 mm
- B. 350 mm
- C. 400 mm
- D. 450 mm
- E. 500 mm Discuss
Structural Design Specifications problems
Search Results
Correct Answer:
Correct Answer: average of two values
Correct Answer: 33%
Correct Answer: 5%
Correct Answer: 28 days
Correct Answer: both (a) and (d)
Correct Answer: 1500 kg/cm2
Correct Answer: 5 mm
Correct Answer: - 6 mm to + 12 mm
Correct Answer: 450 mm
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.