logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Highway Engineering Comments

  • Question
  • On the recommendations of Nagpur Conference, the minimum width of a village road may be


  • Options
  • A. 2.45 m
  • B. 2.75 m
  • C. 3.66 m
  • D. 4.90 m
  • E. 5.00 m

  • Correct Answer
  • 2.45 m 


  • Highway Engineering problems


    Search Results


    • 1. While calculating the overtaking sight distance, the height of the object above road surface, is assumed

    • Options
    • A. Zero
    • B. 50 cm
    • C. 75 cm
    • D. 100 cm
    • E. 120 cm
    • Discuss
    • 2. Pick up the correct statement from the following:

    • Options
    • A. The corss fall of the shoulder should be at least 0.5% steeper than camber
    • B. On superelevated sections, the shoulders should be provided a cross fall equal to camber
    • C. Earthern roads in general are provided steepest crossfall
    • D. All the above.
    • Discuss
    • 3. The width of pavement in addition to a gravelled berm 1 m on either side for a two directional traffic recommended by Nagpur Conference of Chief Engineers, is

    • Options
    • A. 4.7 m
    • B. 5.7 m
    • C. 6.7 m
    • D. 7.7 m
    • E. 8.7 m
    • Discuss
    • 4. For calculating the tractive force along an upgrade of an asphalt road, the most probable value of the co-efficient of traction resistance ? is assumed

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 5. If E is the modulus of elasticity of the concrete in kg/cm2, d is the slab thickness in cm, is the Poisson's ratio for the concrete, k is the sub-grade modulus kg/cm3, the radius r of relative stiffness in cm,

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. Set-back distance is the distance between

    • Options
    • A. road land boundary and building line
    • B. road land boundary and control line
    • C. building line and control line
    • D. road land boundary and control line.
    • Discuss
    • 7. Over taking time required for a vehicle with design speed 50 km ph and overtaking acceleration 1.25 m/sec2 to overtake a vehicle moving at a speed 30 km ph, is

    • Options
    • A. 5.0 secs
    • B. 6.12 secs
    • C. 225.48 secs
    • D. 30 secs
    • Discuss
    • 8. Along horizontal curves, if centrifugal force exceeds lateral friction, vehicles may

    • Options
    • A. skid
    • B. slip
    • C. not be affected
    • D. none of these.
    • Discuss
    • 9. The top height of a route marker above crown level is

    • Options
    • A. 1.50 m
    • B. 1.75 m
    • C. 2.00 m
    • D. 2.25 m
    • Discuss
    • 10. Full amount of extra width of a pavement on the curve, is provided at

    • Options
    • A. beginning of the transition curve
    • B. centre of the transition curve
    • C. beginning of the circular curve
    • D. centre of the circular curve.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment