CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Civil Engineering
‣
Highway Engineering
Comments
Question
If cross slope of a country is upto 10% the terain is classified as
Options
A. plain
B. rolling
C. mountainous
D. steep.
Correct Answer
plain
Highway Engineering problems
Search Results
1. Interior thickness of concrete road slab for design wheel load 6300 kg and permissible flexural stress 21 kg/cm
2
, is
Options
A. 17.0 cm
B. 25.5 cm
C. 34.0 cm
D. 42.5 cm
E. 50.0 cm
Show Answer
Scratch Pad
Discuss
Correct Answer: 25.5 cm
2. The normal road land width for a National or State highway, in open areas should be
Options
A. 45 m
B. 30 m
C. 24 m
D. 20 m
Show Answer
Scratch Pad
Discuss
Correct Answer: 45 m
3. The gradients of trace cuts for hilly roads, are kept
Options
A. equal to ruling gradient
B. 10 tO 20 per cent easier than ruling gradients
C. 10 to 20 per cent steeper than ruling gradients
D. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: 10 tO 20 per cent easier than ruling gradients
4. To prevent a head-on-collision of vehicles travelling in opposite directions along four-lane roads
Options
A. markings on the road are provided
B. physical dividers are provided
C. area dividers are provided
D. medians of wide area are provided
E. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: medians of wide area are provided
5. If the width of carriage way is 12.5 metres, outer edge 50 cm higher than the inner edge, the required super elevation is
Options
A. 50 cm
B. 1 in 25
C. 1 in 400
D. 1 in 40
E. 1 in 24
Show Answer
Scratch Pad
Discuss
Correct Answer: 1 in 25
6. If present A.D.T. is 5000 vehicles and annual increase is 10%, the average future flow after 5 years will be
Options
A. 6050 vehicles
B. 7050 vehicles
C. 8050 vehicles
D. 9050 vehicles
Show Answer
Scratch Pad
Discuss
Correct Answer: 8050 vehicles
7. Three points, A, B and C 500 m apart on a straight road have 500 m, 505 m and 510 m as their reduced levels. The road is said to have
Options
A. no gradient between
A
and
C
B. a positive gradient between
A
and
C
C. a negative gradient between
A
and
C
D. a negative gradient between
A
and
B
E. a positive gradient between
A
and
B
followed by a negative gradient between
B
to
C
.
Show Answer
Scratch Pad
Discuss
Correct Answer: a positive gradient between
A
and
B
followed by a negative gradient between
B
to
C
.
8. Pick up the correct statement from the following:
Options
A. Detailed survey is carried out for a strip of land about 15 m on either side of the trace cut along straight portions
B. Detailed survey is carried out for a strip of land about 30 m at sharp curves
C. Levels are taken along the trace cut at an interval of 20 m
D. Contour interval is generally adopted at 2 metres vertical interval
E. All the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: All the above.
9. If
d
is the economic designed depth of a slab, the thickness of the cement concrete pavement slab at interior, is kept
Options
A. 1.275
d
B. 1.125
d
C. 0.85
d
D. 0.75
d
E. 0.60
d
Show Answer
Scratch Pad
Discuss
Correct Answer: 0.85
d
10. In case of cement concrete pavements, pick up the incorrect statement
Options
A. tractive resistance is low
B. initial cost of construction is high
C. initial cost of construction is low
D. visibility during nights is high
E. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: initial cost of construction is low
Comments
There are no comments.
Enter a new Comment
Save
More in Civil Engineering:
Advanced Surveying
Airport Engineering
Applied Mechanics
Building Construction
Building Materials
Concrete Technology
Construction Management
Docks and Harbours
Elements of Remote Sensing
Engineering Economy
Estimating and Costing
GATE Exam Questions
Highway Engineering
Hydraulics
Irrigation
Railways
RCC Structures Design
SI Units
Soil Mechanics and Foundation Engineering
Steel Structure Design
Strength of Materials
Structural Design Specifications
Surveying
Theory of Structures
Tunnelling
UPSC Civil Service Exam Questions
Waste Water Engineering
Water Resources Engineering
Water Supply Engineering