Discussion
Home ‣ Civil Engineering ‣ Highway Engineering Comments
- Question
The number of vehicles moving in a specified direction on a roadway that pass a given point during specified unit of time, is called
Options- A. traffic volume
- B. traffic density
- C. basic capacity
- D. traffic capacity.
- Correct Answer
- traffic volume
- 1. Pavement is said to be flexible if it contains
Options- A. water bound macadam surface
- B. stabilised soil base constructed of lime cement or tar
- C. bitumen-bound stone layer of varying aggregates
- D. lean concrete base
- E. all the above. Discuss
- 2. Design of horizontal curves on highways, is based on
Options- A. design speed of vehicles
- B. permissible friction on the road surface
- C. permissible centrifugal ratio
- D. permissible maximum super-elevation
- E. all the above. Discuss
- 3. If the radii of a compound curve and a reverse curve are respectively the same, the length of common tangent
Options- A. of compound curve will be more
- B. of reverse curve will be more
- C. of both curves will be equal
- D. none of these. Discuss
- 4. Minimum stopping distance for moving vehicles on road with a design speed of 80 km/hour, is
Options- A. 80 m
- B. 100 m
- C. 120 m
- D. 150 m
- E. 200 m Discuss
- 5. Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2, is
Options- A. 70 kg/sq cm
- B. 80 kg/sq cm
- C. 90 kg/sq cm
- D. 100 kg/sq cm Discuss
- 6. The perpendicular offset from the tan-get to the central point of the circular curve, is
Options- A. R sin ?/2
- B. R cos ?/2
- C. R (1 - cos ?/2)
- D. R (1 - sin ?/2)
- E. none of these. Discuss
- 7. Side drains on both sides of a hill road, are essential when the road is
Options- A. along the spur curves
- B. along the re-entrant curves
- C. in cutting
- D. none of these. Discuss
- 8. If no super elevation is provided on a road along curves, pot holes may develop at
Options- A. inner edge of the road
- B. outer edge of the road
- C. centre of the road
- D. no where on the road. Discuss
- 9. If cross slope of a country is greater than 60%, the terrain is classified as
Options- A. rolling
- B. mountainous
- C. steep
- D. plain. Discuss
- 10. The width of road pavements, depends upon
Options- A. width of traffic lane
- B. number of traffic
- C. width of median strip
- D. all the above. Discuss
Highway Engineering problems
Search Results
Correct Answer: all the above.
Correct Answer: all the above.
Correct Answer: of both curves will be equal
Correct Answer: 120 m
Correct Answer: 90 kg/sq cm
Correct Answer: R (1 - cos ?/2)
Correct Answer: in cutting
Correct Answer: outer edge of the road
Correct Answer: steep
Correct Answer: all the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.