Discussion
Home ‣ Civil Engineering ‣ Highway Engineering Comments
- Question
The first stage of deciding the alignment of a hill road, is
Options- A. reconnaissance
- B. detailed survey
- C. trace-out
- D. preliminary survey.
- Correct Answer
- reconnaissance
- 1. At a road junction, 7 cross conflict points are severe if
Options- A. both are one-way roads
- B. both are two-way roads
- C. one is two-way road and other is one-way road
- D. none of these. Discuss
- 2. For the administration of road transport, a Motor Vehicle Act was enacted in
Options- A. 1927
- B. 1934
- C. 1939
- D. 1947
- E. 1950 Discuss
- 3. In factory buildings, the horizontal beams spanning between the wall columns supporting a wall covering, are called
Options- A. stringers
- B. trimmers
- C. girts
- D. lintels. Discuss
- 4. Design of a riveted joint is based on the assumption:
Options- A. Bending stress in rivets is accounted for
- B. Riveted hole is assumed to be completely filled by the rivet
- C. Stress in the plate in not uniform
- D. Friction between plates is taken into account
- E. None of these. Discuss
- 5. A beam may be designed as a cased beam if
Options- A. section is of double open channel form with the webs not less than 40 mm apart
- B. overall depth and width of the steel section do not exceed 750 and 450 mm respectively.
- C. beam is solidly encased in concrete with 10 mm aggregate having 28 days strength 160 kg/cm2
- D. width of the solid casing is kept at least 100 mm more than the width of the steel flange and having a concrete cover of 50 mm
- E. all the above. Discuss
- 6. The shape of a vertical curve, is
Options- A. parabolic
- B. elliptical
- C. circular
- D. spiral
- E. all the above. Discuss
- 7. While designing hair pin bends on higways, the minimum
Options- A. designed speed is 20 km/hour
- B. gradient is 1 in 40
- C. gradient is 1 in 200
- D. superelevations is 1 in 10
- E. All the above. Discuss
- 8. Minimum thickness of a layer of fine sand required to cut off capillary rise of water completely, should be
Options- A. 40 cm
- B. 52 cm
- C. 64 cm
- D. 76 cm
- E. 80 cm Discuss
- 9. The ideal shape of a transition curve, is
Options- A. clothoid
- B. cubic spiral
- C. cubic parabola
- D. lamniscate
- E. none of these. Discuss
- 10. Passing zones are generally not provided on
Options- A. summit curves
- B. horizontal curves
- C. two lane highways
- D. all the above. Discuss
Highway Engineering problems
Search Results
Correct Answer: one is two-way road and other is one-way road
Correct Answer: 1939
Correct Answer: girts
Correct Answer: Riveted hole is assumed to be completely filled by the rivet
Correct Answer: all the above.
Correct Answer: parabolic
Correct Answer: All the above.
Correct Answer: 76 cm
Correct Answer: clothoid
Correct Answer: all the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.