Discussion
Home ‣ Civil Engineering ‣ Steel Structure Design Comments
- Question
The allowable stress in axial tension is generally kept less if thickness of the member is more than
Options- A. 10 mm
- B. 12 mm
- C. 15 mm
- D. 20 mm
- E. 22 mm
- Correct Answer
- 20 mm
- 1. Perforated cover plates are particularly suitable for built up sections consisting of
Options- A. channels placed back to back
- B. channels placed toe to toe
- C. four angle box section
- D. all the above. Discuss
- 2. A riveted joint may experience
Options- A. shear failure
- B. shear failure of plates
- C. bearing failure
- D. bearing failure of rivets
- E. all the above. Discuss
- 3. Effective length of a column effectively held in position and restrained in direction at both ends, is
Options- A. L
- B. 0.67 L
- C. 0.85 L
- D. 1.5 L
- E. 2 L Discuss
- 4. A fillet weld whose axis is parallel to the direction of the applied load, is known as
Options- A. diagonal filler weld
- B. end fillet weld
- C. side fillet weld
- D. all the above. Discuss
- 5. In case horizontal stiffeners are not used, the distance between vertical legs of flange angles at the top and bottom of a plate girder, is known as
Options- A. overall depth
- B. clear depth
- C. effective depth
- D. none of these. Discuss
- 6. Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is
Options- A. L
- B. 0.67 L
- C. 0.85 L
- D. 1.5 L
- E. 2 L Discuss
- 7. The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed
Options- A. 60
- B. 45
- C. 35
- D. 25
- E. 20 Discuss
- 8. If d is the distance between the flange angles, the vertical stiffeners in plate girders without horizontal stiffeners, are spaced at a distance not less than
Options- A. 0.15 d
- B. 0.22 d
- C. 0.33 d
- D. 0.44 d Discuss
- 9. Assuming the values of maximum deviation ?P and ?E to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is
Options- A. 1.00
- B. 0.67
- C. 1.67
- D. 2.67
- E. none of these. Discuss
- 10. The tensile strength of mild steel for bolts and nuts should not be less than
Options- A. 32 kg/mm2
- B. 36 kg/mm2
- C. 40 kg/mm2
- D. 44 kg/mm2 Discuss
Steel Structure Design problems
Search Results
Correct Answer: four angle box section
Correct Answer: all the above.
Correct Answer: 0.67 L
Correct Answer: side fillet weld
Correct Answer: clear depth
Correct Answer: 2 L
Correct Answer: 35
Correct Answer: 0.33 d
Correct Answer: 1.67
Correct Answer: 44 kg/mm2
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.