Discussion
Home ‣ Civil Engineering ‣ Steel Structure Design Comments
- Question
To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
Options- A.
- B.
- C.
- D.
- E.
- Correct Answer
-
- 1. For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
Options- A. HTW grade of thickness exceeding 32 mm
- B. HT grade of thickness exceeding 45 mm
- C. HT grade of thickness not exceeding 45 mm
- D. All the above. Discuss
- 2. The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
Options- A. 180
- B. 200
- C. 250
- D. 300
- E. 350 Discuss
- 3. To the calculated area of cover plates of a built-up beam, an allowance for rivet holes to be added, is
Options- A. 10%
- B. 13%
- C. 15%
- D. 18%
- E. 20%. Discuss
- 4. In double lacing, the thickness t of flat lacing is
Options- A. t < 1/40 th length between inner end rivets
- B. t < 1/50 th length between inner end rivets
- C. t < 1/60 th length between inner end rivets
- D. t < 1/70 th length between inner end rivets
- E. none of these. Discuss
- 5. If d is the clear depth of a plate girder, t is the minimum required thickness of the web, C is the maximum clear distance between vertical stiffeners, the moment of inertia of a pair of stiffeners about the centre line of the web, is
Options- A.
- B.
- C.
- D.
Discuss
- 6. The permissible stress to which a structural member can be subjected to, is known as
Options- A. bearing stress
- B. working stress
- C. tensile stress
- D. compressive stress
- E. all the above. Discuss
- 7. Diameter of a rivet hole is made larger than the diameter of the rivet by
Options- A. 1.0 mm for rivet diameter upto 12 mm
- B. 1.5 mm for rivet diameter exceeding 25 mm
- C. 2.0 mm for rivet diameter over 25 mm
- D. none of these. Discuss
- 8. Factor of safety is the ratio of
Options- A. yield stress to working stress
- B. tensile stress to working stress
- C. compressive stress to working stress
- D. bearing stress to working stress
- E. bearing stress to yield stress. Discuss
- 9. When the length of a tension member is too long
Options- A. a wire rope is used
- B. a rod is used
- C. a bar is used
- D. a single angle is used. Discuss
- 10. Bulb angles are used in
Options- A. column building
- B. bridge building
- C. ship building
- D. water tank building. Discuss
Steel Structure Design problems
Search Results
Correct Answer: All the above.
Correct Answer: 180
Correct Answer: 13%
Correct Answer: t < 1/60 th length between inner end rivets
Correct Answer:
Correct Answer: working stress
Correct Answer: 2.0 mm for rivet diameter over 25 mm
Correct Answer: yield stress to working stress
Correct Answer: a bar is used
Correct Answer: ship building
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.