logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Steel Structure Design Comments
  • Question

  • The most commonly used sections in lateral system to carry shear force in built up columns, are


  • Options
  • A. rolled steel flats
  • B. rolled angles
  • C. rolled channels
  • D. all the above.

  • Correct Answer
  • all the above. 

    • Steel Structure Design problems

    Search Results

    • 1. An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2, the thickness (t) of the slab base, is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 2. A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed

    • Options
    • A. 180
    • B. 200
    • C. 250
    • D. 300
    • E. 350
      • Discuss
    • 3. The rivets which are heated and then driven in the field, are known

    • Options
    • A. power driven shop rivets
    • B. power driven field rivets
    • C. hand driven rivets
    • D. cold driven rivets
    • E. field rivets.
      • Discuss
    • 4. The effective length of a compression member of length L, held in position and restrained in direction at both ends, is

    • Options
    • A. L
    • B. 0.67 L
    • C. 0.85 L
    • D. 1.5 L
    • E. 2 L
      • Discuss
    • 5. The bending moment for filler joists at the middle of at intermediate span, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 6. The maximum axial load which is just sufficient to keep a column in a small deflected shape, is called

    • Options
    • A. crippling load
    • B. buckling load
    • C. critical load
    • D. all the above.
      • Discuss
    • 7. The spans are considered approximately equal if the longest span does not exceed the shortest span by more than

    • Options
    • A. 5%
    • B. 10%
    • C. 15%
    • D. 20%
      • Discuss
    • 8. When two plates are placed end to end and are joined by two cover plates, the joint is known as

    • Options
    • A. lap joint
    • B. butt joint
    • C. chain riveted lap joint
    • D. zig-zag riveted lap joint
    • E. double cover butt joint.
      • Discuss
    • 9. Poisson's ratio for steel within elastic limit, ranges from

    • Options
    • A. 0.15 to 0.20
    • B. 0.25 to 0.24
    • C. 0.25 to 0.33
    • D. 0.33 to 0.35
    • E. 0.45 to 0.50
      • Discuss
    • 10. If p and d are pitch and gross diameter of rivets, the efficiency (?) of the riveted joint, is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.