logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Steel Structure Design Comments
  • Question

  • A simply supported beam carrying a central load, will be safe in deflection if the ratio of its span to depth, is


  • Options
  • A. < 19
  • B. < 24
  • C. > 19
  • D. > 24
  • E. > 37

  • Correct Answer
  • < 24 

    • Steel Structure Design problems

    Search Results

    • 1. A 20 mm dia steel bar which is subjected to an axial tension of 2300 kg/cm2 produces a strain of 0.004 cm. If Young's modulus of steel is 2.1 x 106 kg/cm2, the bar is

    • Options
    • A. in the elastic range
    • B. in the plastic range
    • C. at yield point
    • D. none of these.
      • Discuss
    • 2. When a large value of radius of gyration is not required

    • Options
    • A. channels are placed back to back
    • B. channel flanges are kept inward
    • C. channel flanges are kept outward
    • D. none of these.
      • Discuss
    • 3. According to IS : 800-1962 the permissible bending stress in steel slab plates, is

    • Options
    • A. 1500 kg/cm2
    • B. 1420 kg/cm2
    • C. 2125 kg/cm2
    • D. 1890 kg/cm2
      • Discuss
    • 4. Spans of continuous fillers are considered approximately equal if the longest span does not exceed the shortest span by more than

    • Options
    • A. 5%
    • B. 10%
    • C. 15%
    • D. 20%
    • E. 25%
      • Discuss
    • 5. If P is the load applied to a bracket with an eccentricity e, the resisting moment F exerted by a rivet at a distance rn from the centre of gravity, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 6. If the slenderness ratio is greater than 160, the allowable stress in axial compression is multiplied by a factor (1.2 - (l/xy) where x is

    • Options
    • A. 200
    • B. 400
    • C. 600
    • D. 800
    • E. 1000
      • Discuss
    • 7. For double angles carrying tension, placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to cross sectional area of

    • Options
    • A. the section
    • B. the section plus area of rivet holes
    • C. the section minus area of rivet holes
    • D. tthe section multiplied by the area of the rivet hole.
      • Discuss
    • 8. A major beam in a building structure, is known as

    • Options
    • A. a girder
    • B. a floor beam
    • C. a main beam
    • D. all the above.
      • Discuss
    • 9. The moment of the couple set up in a section of a beam by the logitudinal compressive and tensile force, is known as

    • Options
    • A. bending moment
    • B. moment of resistance
    • C. flexural stress moment
    • D. none of these.
      • Discuss
    • 10. The bending moment for filler joists at the middle of at intermediate span, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.