Discussion
Home ‣ Civil Engineering ‣ Steel Structure Design Comments
- Question
Rolled steel Tee-sections are used
Options- A. as columns
- B. with flat strips to connect plates in steel rectangular tanks
- C. as built up sections to resist axial tension
- D. none of these.
- Correct Answer
- with flat strips to connect plates in steel rectangular tanks
- 1. The difference in the reservoir level and the lowest point of the water mains is 180 m. The expected pressure due to water hammer is 7.5 kg/cm2 in a pressure conduit of diameter 1 m. Assuming the efficiency of the riveted joints of the pipe as 0.6 and minimum cover 3 mm for corrosion, the thickness of the pipe materials, is
Options- A. 10 mm
- B. 15 mm
- C. 20 mm
- D. 25 mm
- E. 30 mm. Discuss
- 2. A pressure conduit carrying water beneath a stream or a canal, is known as
Options- A. sag
- B. depressed pipe
- C. inverted syphon
- D. all the above. Discuss
- 3. The factor for the selection of pumping station site, is
Options- A. distance of the source of contamination or pollution
- B. height above the H.F.L. of the river
- C. future expansion
- D. proximity of the site from the railway station
- E. all the above. Discuss
- 4. Pick up the incorrect statement from the following :
Options- A. The pH value of water indicates the logarithm of reciprocal of hydrogen ion concentration in water
- B. Higher value of pH means lower hydrogen ion concentration
- C. Lower value of pH means higher hydrogen ion contraction
- D. Lower value of pH gives alkaline solution
- E. None of these. Discuss
- 5. Perched acquifers generally occur
Options- A. below water table
- B. above water table
- C. in acquicludes
- D. in artesian acquifers
- E. none of these. Discuss
- 6. The minimum pitch of rivet holes of diameter d should not be less than
Options- A. d
- B. 1.25 d
- C. 1.5 d
- D. 2 d
- E. 2.5 d Discuss
- 7. The Indian standard code which deals with steel structures, is
Options- A. IS : 875
- B. IS : 800
- C. IS : 456
- D. IS : 1893 Discuss
- 8. The permissible bearing stress in steel, is
Options- A. 1500 kg/cm2
- B. 1890 kg/cm2
- C. 2025 kg/cm2
- D. 2340 kg/cm2
- E. 2250 kg/cm2 Discuss
- 9. The gross diameter of a rivet is the diameter of
Options- A. cold rivet before driving
- B. rivet after driving
- C. rivet hole
- D. none of these. Discuss
- 10. The strength of a riveted lap joint is equal to its
Options- A. shearing strength
- B. bearing strength
- C. tearing strength
- D. least of (a), (b) and (c)
- E. greatest of (a) (b) and (c). Discuss
Steel Structure Design problems
Search Results
Correct Answer: 20 mm
Correct Answer: all the above.
Correct Answer: all the above.
Correct Answer: Lower value of pH gives alkaline solution
Correct Answer: above water table
Correct Answer: 2.5 d
Correct Answer: IS : 800
Correct Answer: 1890 kg/cm2
Correct Answer: rivet after driving
Correct Answer: least of (a), (b) and (c)
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.