Discussion
Home ‣ Civil Engineering ‣ Water Supply Engineering Comments
- Question
At break point of chlorination,
Options- A. chlorine is used to oxidise
- B. residual chloride is zero
- C. residual chloride is maximum
- D. residual chlorine reappears.
- Correct Answer
- residual chlorine reappears.
- 1. Pick up the correct statement from the following :
Options- A. Copper pipes are highly resistant to acidic and alkaline water
- B. Wrought iron pipes are lighter than cast iron pipes
- C. Wrought iron pipes corrode quickly and are less durable
- D. Wrought iron pipes coated with zinc, are called galvanised iron pipes
- E. All the above. Discuss
- 2. Rapid sand filter
Options- A. should be preceeded by coagulation and sedimentation
- B. uses rapid sand as filter media
- C. is used after slow sand filtering has been done
- D. can combine disinfection also. Discuss
- 3. The maximum permissible hardness for public supplies is
Options- A. 95 mg/litre
- B. 105 mg/litre
- C. 115 mg/litre
- D. 125 mg/litre
- E. 150 mg/litre. Discuss
- 4. Per capita demand of water is calculated in litres
Options- A. per person per day
- B. per person per month
- C. per person per year
- D. none of these. Discuss
- 5. In rapid sand filters the ratio of length and diameter of the lateral, should not be greater than
Options- A. 10
- B. 15
- C. 20
- D. 25 Discuss
- 6. Low turbidity of water is detected by
Options- A. Turbidity tube
- B. Jackson turbidity meter
- C. Baylis turbidimeter
- D. Hellipe turbidimeter
- E. None of these. Discuss
- 7. For 3.25 x 10-2 cumecs discharging from a well, a pump is installed to lift water against a total head of 30 m. The minimum required horse power, is
Options- A. 10 H.P.
- B. 15 H.P.
- C. 18 H.P.
- D. 20 H.P.
- E. 25 H.P. Discuss
- 8. Suction lift of a pump depends upon
Options- A. atmospheric pressure
- B. water temperature
- C. velocity of water in suction pipe
- D. frictional losses
- E. all the above. Discuss
- 9. For complete stabilisation of organic matter in polluted water, it takes
Options- A. 5 days
- B. 10 days
- C. 20 days
- D. 30 days
- E. 40 days. Discuss
- 10. Capacity of soil to absorb moisture, is generally known as
Options- A. permeability
- B. porosity
- C. infiltration capacity
- D. perviousness. Discuss
Water Supply Engineering problems
Search Results
Correct Answer: All the above.
Correct Answer: should be preceeded by coagulation and sedimentation
Correct Answer: 115 mg/litre
Correct Answer: per person per day
Correct Answer: 20
Correct Answer: Baylis turbidimeter
Correct Answer: 20 H.P.
Correct Answer: all the above.
Correct Answer: 30 days
Correct Answer: infiltration capacity
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.