logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Water Supply Engineering Comments

  • Question
  • If w is the weight of water per cubic metre, Q is the discharge in cubic metres per sec and H is the total head, the required water horse power of the pump, is


  • Options
  • A. If w is the weight of water per cubic metre, Q is the discharge in cubic metres per sec and H is the
  • B. If w is the weight of water per cubic metre, Q is the discharge in cubic metres per sec and H is the
  • C. If w is the weight of water per cubic metre, Q is the discharge in cubic metres per sec and H is the
  • D. If w is the weight of water per cubic metre, Q is the discharge in cubic metres per sec and H is the
  • E. none of these.

  • Correct Answer
  •  


  • Water Supply Engineering problems


    Search Results


    • 1. The approximate diameter of a water mains for supplying 7.2 mld with a velocity 1.2 m/sec, is

    • Options
    • A. 24 cm
    • B. 26 cm
    • C. 28 cm
    • D. 30 cm
    • E. 32 cm.
    • Discuss
    • 2. The order of existence of three portions of water in a reservoir from the bottom to top is

    • Options
    • A. useful storage + surcharge storage + dead storage
    • B. useful storage + dead storage + surcharge storage
    • C. dead storage + useful storage + surcharge storage
    • D. surcharge storage + useful storage + dead storage
    • E. none of these.
    • Discuss
    • 3. Pick up the correct statement from the following :

    • Options
    • A. At a particular speed of operation, the head produced decreases with the increase of discharge
    • B. At zero discharge, discharge valve remaining closed, the head developed is maximum which is known as shut-off head
    • C. At a particular speed the discharge at which efficiency of a pump is maximum, is known as normal discharge
    • D. The brake horse power required from the primemover to drive the pump, increases with the increase of discharge
    • E. all the above.
    • Discuss
    • 4. Aqueducts are generally designed

    • Options
    • A. circular
    • B. rectangular
    • C. horse shoe section
    • D. all the above.
    • Discuss
    • 5. The nitrate concentration in domestic water supplies, is generally limited to

    • Options
    • A. 10 ppm
    • B. 15 ppm
    • C. 25 ppm
    • D. 30 ppm
    • E. 45 ppm.
    • Discuss
    • 6. Hardness of water can be removed by boiling if it is due to

    • Options
    • A. calcium bicarbonates
    • B. calcium sulphates
    • C. calcium chloride
    • D. calcium nitrates.
    • Discuss
    • 7. To control the growth of algae in reservoirs, the compound which is used, is

    • Options
    • A. bleaching powder
    • B. copper sulphate
    • C. lime solution
    • D. alum solution
    • E. all the above.
    • Discuss
    • 8. Pick up the correct statement from the following :

    • Options
    • A. For determination of small colour intensities, tintometer is generally used
    • B. The odour of water sample is generally measured by a term called odour intensity
    • C. The colour of water sample may be detected by Nessler tube
    • D. Specific conductivity of water measures the amount of dissolved salt
    • E. All the above.
    • Discuss
    • 9. Pick up the wrong nominal internal diameter of cast iron (spun) pipes in mm from the following :

    • Options
    • A. 300
    • B. 400
    • C. 500
    • D. 550
    • E. 600
    • Discuss
    • 10. Carbonates in water produce

    • Options
    • A. temporary hardness
    • B. permanent hardness
    • C. acidity
    • D. alkanity.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment