logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Water Supply Engineering Comments

  • Question
  • Pressure exerted at 90° bend in a pipe of cross-sectional area A and carrying water with a velocity V under a pressure p, is


  • Options
  • A. Pressure exerted at 90° bend in a pipe of cross-sectional area A and carrying water with a velocity
  • B. Pressure exerted at 90° bend in a pipe of cross-sectional area A and carrying water with a velocity
  • C. Pressure exerted at 90° bend in a pipe of cross-sectional area A and carrying water with a velocity
  • D. Pressure exerted at 90° bend in a pipe of cross-sectional area A and carrying water with a velocity

  • Correct Answer
  •  


  • Water Supply Engineering problems


    Search Results


    • 1. The valve shown in the below figure, is generally known as

    • Options
    • A. air valve
    • B. pressure relief valve
    • C. sluice valve
    • D. none of these.
    • Discuss
    • 2. Water gets evaporated from water surfaces and land surfaces, get converted into water drops at lower temperatures, flows over ground surface and finally meets its source, i.e. lake, sea, etc. This entire process is generally known as

    • Options
    • A. hydrological cycle
    • B. water cycle
    • C. evaporation and precipitation cycle
    • D. all the above.
    • Discuss
    • 3. Pick up the incorrect statement from the following :

    • Options
    • A. Free surface ground water is subjected to atmospheric pressure
    • B. Water table surface rises and falls with seasons
    • C. Depth of water table is directly proportional to the rate of drawal of water
    • D. Level of water table remains stationary
    • E. None of these.
    • Discuss
    • 4. The most commonly used chemical for dechlorination of water, is

    • Options
    • A. sodium thiosulphate
    • B. sodium bisulphate
    • C. sodium sulphite
    • D. sulphur-dioxide
    • E. all the above.
    • Discuss
    • 5. In the equation of a logistic curve of population growth, the constant m is

    • Options
    • A. Ps x P
    • B.
    • C.
    • D. KPs .
    • Discuss
    • 6. Cast iron pipes are generally preferred to, because

    • Options
    • A. of moderate cost
    • B. of ease to join
    • C. of durability
    • D. of longer life
    • E. all the above.
    • Discuss
    • 7. The fire demand for a city of 50, 000 population, according to Godrich formula, is

    • Options
    • A. 40 mld
    • B. 42 mld
    • C. 44 mld
    • D. 48 mld.
    • Discuss
    • 8. Pick up the correct statement from the following :

    • Options
    • A. Water with hardness upto 75 ppm is considered soft
    • B. Water with hardness more than 200 ppm is considered hard
    • C. Water needed for laundaries should contain hardness less than 75 ppm
    • D. To provide taste during drinking, water should possess hardness between 75 to 120
    • E. All the above.
    • Discuss
    • 9. Most commonly used section in grade aqueducts, is

    • Options
    • A. circular
    • B. rectangular
    • C. parabolic
    • D. horse shoe section.
    • Discuss
    • 10. Specific capacity or yield of wells, is generally expressed, as

    • Options
    • A. m3 per sec
    • B. m3/hour
    • C. m3/hour/m2
    • D. m3/hour/m2/m
    • E. m3/hour/m2/sec.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment