logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Water Supply Engineering Comments

  • Question
  • The permissible pH value for public water supplies may range between


  • Options
  • A. 4.5 to 5.5
  • B. 5.5 to 6.5
  • C. 6.5 to 8.5
  • D. 8.5 to 10.5
  • E. none of these.

  • Correct Answer
  • 6.5 to 8.5 


  • Water Supply Engineering problems


    Search Results


    • 1. The maximum permitted loss of head in a rapid sand filter, is

    • Options
    • A. 1 m
    • B. 2 m
    • C. 3 m
    • D. 4 m
    • E. 5 m.
    • Discuss
    • 2. The cast iron pipes for water supply system are used for

    • Options
    • A. durability
    • B. strength
    • C. easy connection
    • D. low maintenance cost
    • E. all the above.
    • Discuss
    • 3. For centrifugal pumps

    • Options
    • A. initial cost is low
    • B. limited space is required
    • C. the discharge obtained is steady and non-pulsating
    • D. all the above.
    • Discuss
    • 4. Turbidity of water may be caused due to

    • Options
    • A. Suspended clay
    • B. Suspended silt
    • C. finely divided organic material
    • D. all the above.
    • Discuss
    • 5. Service connections to consumers houses, are generally provided with

    • Options
    • A. copper pipes
    • B. hume pipes
    • C. galvanised iron pipes
    • D. P.V.C. pipes
    • E. none of these.
    • Discuss
    • 6. Standard process of chlorination of water, is done by

    • Options
    • A. plain chlorination
    • B. pre-chlorination
    • C. post-chlorination
    • D. double chlorination.
    • Discuss
    • 7. For maximum alkalinity of water, pH value should be

    • Options
    • A. zero
    • B. less than 7
    • C. more than 7
    • D. 14
    • E. 21
    • Discuss
    • 8. The strainer type tube well, is unsuitable for

    • Options
    • A. coarse gravels
    • B. fine sandy strata
    • C. clean gravels
    • D. none of these.
    • Discuss
    • 9. The four major water supply distribution systems, are

    • Options
    • A. dead end, tree, grid iron and reticulation
    • B. dead end, tree, grid iron and circular
    • C. tree, grid iron, ring and radial
    • D. tree, reticulation, circular and ring.
    • Discuss
    • 10. Critical time for developing a water hammer, is the time required for

    • Options
    • A. closing the valve
    • B. the wave to travel from valve to the reservoir
    • C. the wave to travel from the valve to the reservoir and back
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment