logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • At either end of a plane frame, maximum number of possible transverse shear forces, are


  • Options
  • A. one
  • B. two
  • C. three
  • D. four
  • E. zero.

  • Correct Answer
  • one 


  • Strength of Materials problems


    Search Results


    • 1. The phenomenon of slow growth of strain under a steady tensile stress, is called

    • Options
    • A. yielding
    • B. creeping
    • C. breaking
    • D. none of these.
    • Discuss
    • 2. The B.M. diagram of the beam shown in below figure, is

    • Options
    • A. a rectangle
    • B. a triangle
    • C. a trapezium
    • D. a parabola
    • E. a circle.
    • Discuss
    • 3. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about its neutral axis, the difference between the maximum and mean shear stresses in the web is,

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 4. For a beam having fixed ends, the unknown element of the reactions, is

    • Options
    • A. horizontal components at either end
    • B. vertical components at either end
    • C. horizontal component at one end and vertical component at the other
    • D. horizontal and vertical components at both the ends.
    • Discuss
    • 5. Ties are load carrying members of a frame, which are subjected to

    • Options
    • A. transverse loads
    • B. axial tension loads
    • C. axial compressive loads
    • D. torsional loads.
    • Discuss
    • 6. A solid circular shaft of diameter d is subjected to a torque T. The maximum normal stress induced in the shaft, is

    • Options
    • A. zero
    • B.
    • C.
    • D. none of these.
    • Discuss
    • 7. The slenderness ratio of a vertical column of square cross- section of 10 cm side and 500 cm long, is

    • Options
    • A. 117.2
    • B. 17.3
    • C. 173.2
    • D. 137.2
    • E. 13.72
    • Discuss
    • 8. The intensity of direct longitudinal stress in the cross-section at any point distant r from the neutral axis, is proportional to

    • Options
    • A. r
    • B.
    • C. r2
    • D.
    • E. r3.
    • Discuss
    • 9. If p is the internal pressure in a thin cylinder of diameter d and thickness t, the developed hoop stress, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 10. The value of Poisson's ratio always remains

    • Options
    • A. greater than one
    • B. less than one
    • C. equal to one
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment