logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about its neutral axis, the difference between the maximum and mean shear stresses in the web is,


  • Options
  • A. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about
  • B. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about
  • C. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about
  • D. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about

  • Correct Answer
  •  


  • Strength of Materials problems


    Search Results


    • 1. For a beam having fixed ends, the unknown element of the reactions, is

    • Options
    • A. horizontal components at either end
    • B. vertical components at either end
    • C. horizontal component at one end and vertical component at the other
    • D. horizontal and vertical components at both the ends.
    • Discuss
    • 2. Ties are load carrying members of a frame, which are subjected to

    • Options
    • A. transverse loads
    • B. axial tension loads
    • C. axial compressive loads
    • D. torsional loads.
    • Discuss
    • 3. For the same height, the bottom width for no tension,

    • Options
    • A. for triangular section is more than rectangular section
    • B. for rectangular section is more than triangular section
    • C. for triangular section is same as that of a rectangular section
    • D. none of these.
    • Discuss
    • 4. The moment diagram for a cantilever which is subjected to a uniformly distributed load will be a

    • Options
    • A. triangle
    • B. rectangle
    • C. parabola
    • D. cubic parabola.
    • Discuss
    • 5. Strain energy of any member may be defined as work done on it

    • Options
    • A. to deform it
    • B. to resist elongation
    • C. to resist shortening
    • D. all the above.
    • Discuss
    • 6. The B.M. diagram of the beam shown in below figure, is

    • Options
    • A. a rectangle
    • B. a triangle
    • C. a trapezium
    • D. a parabola
    • E. a circle.
    • Discuss
    • 7. The phenomenon of slow growth of strain under a steady tensile stress, is called

    • Options
    • A. yielding
    • B. creeping
    • C. breaking
    • D. none of these.
    • Discuss
    • 8. At either end of a plane frame, maximum number of possible transverse shear forces, are

    • Options
    • A. one
    • B. two
    • C. three
    • D. four
    • E. zero.
    • Discuss
    • 9. A solid circular shaft of diameter d is subjected to a torque T. The maximum normal stress induced in the shaft, is

    • Options
    • A. zero
    • B.
    • C.
    • D. none of these.
    • Discuss
    • 10. The slenderness ratio of a vertical column of square cross- section of 10 cm side and 500 cm long, is

    • Options
    • A. 117.2
    • B. 17.3
    • C. 173.2
    • D. 137.2
    • E. 13.72
    • Discuss


    Comments

    There are no comments.

Enter a new Comment