logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • The moment diagram for a cantilever which is subjected to a uniformly distributed load will be a


  • Options
  • A. triangle
  • B. rectangle
  • C. parabola
  • D. cubic parabola.

  • Correct Answer
  • parabola 


  • Strength of Materials problems


    Search Results


    • 1. Strain energy of any member may be defined as work done on it

    • Options
    • A. to deform it
    • B. to resist elongation
    • C. to resist shortening
    • D. all the above.
    • Discuss
    • 2. The areas of cross-section of a square beam and a circular beam subjected to equal bending moments, are same.

    • Options
    • A. circular beam is more economical
    • B. square beam is more economical
    • C. both the beams are equally strong
    • D. both the beams are equally economical
    • E. none of these.
    • Discuss
    • 3. If all the dimensions of a bar are increased in the proportion n : 1, the proportion with which the maximum stress produced in the prismatic bar by its own weight, will increase in the ratio

    • Options
    • A. 1 : n
    • B. n : 1
    • C. 1 :
    • D. : 1
    • E. 1 : n.
    • Discuss
    • 4. A cast iron T section beam is subjected to pure bending. For maximum compressive stress to be three times the maximum tensile stress, centre of gravity of the section from flange side is

    • Options
    • A. h/4
    • B. h/3
    • C. h/2
    • D. 2/3 h.
    • Discuss
    • 5. If a circular beam of diameter d experiences a longitudinal strain and a lateral strain the volumetric strain is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
    • Discuss
    • 6. For the same height, the bottom width for no tension,

    • Options
    • A. for triangular section is more than rectangular section
    • B. for rectangular section is more than triangular section
    • C. for triangular section is same as that of a rectangular section
    • D. none of these.
    • Discuss
    • 7. Ties are load carrying members of a frame, which are subjected to

    • Options
    • A. transverse loads
    • B. axial tension loads
    • C. axial compressive loads
    • D. torsional loads.
    • Discuss
    • 8. For a beam having fixed ends, the unknown element of the reactions, is

    • Options
    • A. horizontal components at either end
    • B. vertical components at either end
    • C. horizontal component at one end and vertical component at the other
    • D. horizontal and vertical components at both the ends.
    • Discuss
    • 9. If S is the shear force at a section of an I-joist, having web depth d and moment of inertia I about its neutral axis, the difference between the maximum and mean shear stresses in the web is,

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 10. The B.M. diagram of the beam shown in below figure, is

    • Options
    • A. a rectangle
    • B. a triangle
    • C. a trapezium
    • D. a parabola
    • E. a circle.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment