logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • If all the dimensions of a bar are increased in the proportion n : 1, the proportion with which the maximum stress produced in the prismatic bar by its own weight, will increase in the ratio


  • Options
  • A. 1 : n
  • B. n : 1
  • C. 1 : If all the dimensions of a bar are increased in the proportion n : 1, the proportion with which the
  • D. If all the dimensions of a bar are increased in the proportion n : 1, the proportion with which the : 1
  • E. 1 : n.

  • Correct Answer
  • n : 1 


  • Strength of Materials problems


    Search Results


    • 1. A cast iron T section beam is subjected to pure bending. For maximum compressive stress to be three times the maximum tensile stress, centre of gravity of the section from flange side is

    • Options
    • A. h/4
    • B. h/3
    • C. h/2
    • D. 2/3 h.
    • Discuss
    • 2. If a circular beam of diameter d experiences a longitudinal strain and a lateral strain the volumetric strain is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
    • Discuss
    • 3. The moment diagram for a cantilever carrying linearly varying load from zero at its free end and to maximum at the fixed end will be a

    • Options
    • A. triangle
    • B. rectangle
    • C. parabola
    • D. cubic parabola.
    • Discuss
    • 4. The effect of arching a beam, is

    • Options
    • A. to reduce the bending moment throughout
    • B. to increase the bending moment throughout
    • C. nothing on the bending throughout
    • D. ail the above.
    • Discuss
    • 5. The equivalent length of a column fixed at both ends, is

    • Options
    • A. 0.5 l
    • B. 0.7 l
    • C. l
    • D. 2 l
    • E. 1.5 l.
    • Discuss
    • 6. The areas of cross-section of a square beam and a circular beam subjected to equal bending moments, are same.

    • Options
    • A. circular beam is more economical
    • B. square beam is more economical
    • C. both the beams are equally strong
    • D. both the beams are equally economical
    • E. none of these.
    • Discuss
    • 7. Strain energy of any member may be defined as work done on it

    • Options
    • A. to deform it
    • B. to resist elongation
    • C. to resist shortening
    • D. all the above.
    • Discuss
    • 8. The moment diagram for a cantilever which is subjected to a uniformly distributed load will be a

    • Options
    • A. triangle
    • B. rectangle
    • C. parabola
    • D. cubic parabola.
    • Discuss
    • 9. For the same height, the bottom width for no tension,

    • Options
    • A. for triangular section is more than rectangular section
    • B. for rectangular section is more than triangular section
    • C. for triangular section is same as that of a rectangular section
    • D. none of these.
    • Discuss
    • 10. Ties are load carrying members of a frame, which are subjected to

    • Options
    • A. transverse loads
    • B. axial tension loads
    • C. axial compressive loads
    • D. torsional loads.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment