Discussion
Home ‣ Civil Engineering ‣ Strength of Materials See What Others Are Saying!
- Question
A cast iron T section beam is subjected to pure bending. For maximum compressive stress to be three times the maximum tensile stress, centre of gravity of the section from flange side is
Options- A. h/4
- B. h/3
- C. h/2
- D. 2/3 h.
- Correct Answer
- h/4
- 1. The self-cleansing velocity of water flowing through pipe lines, is
Options- A. 2 metres/sec
- B. 1 metre/sec
- C. 0.5 metre/sec
- D. 0.25 metre/sec. Discuss
- 2. The semi-infinite snow albedo is proportional to the square root of the grain radius :
Options- A. in the 0.2 to 0.4 ?m wave length region
- B. in the 0.4 to 0.8 ?m wave length region
- C. in the 0.8 to 1.2 ?m wave length
- D. None of these Discuss
- 3. To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is
Options- A. 1/4 to 1/8
- B. 1/3 to 1/2
- C. 1/2 to 3/4.
- D. none of these. Discuss
- 4. The efficiency of a pump may be taken as
Options- A. 0.55
- B. 0.60
- C. 0.65
- D. 0.70 Discuss
- 5. A wooden block fixed on back side of a door frame on its post, is known as
Options- A. cleat
- B. stop
- C. horn
- D. none of these. Discuss
- 6. If a 30 m chain diverges through a perpendicular distance d from its correct alignment, the error in length, is
Options- A.
- B.
- C.
- D.
- E.
.
Discuss
- 7. In sewers the highest non-scouring velocity is achieved in
Options- A. glazed bricks sewers
- B. cast iron sewers
- C. cement concrete sewers
- D. stone ware sewers. Discuss
- 8. The difference in gradients after full super-elevation and the initial alignment of a road, is known as
Options- A. ruling gradient
- B. rising gradient
- C. compensated gradient
- D. differential gradient
- E. none of these. Discuss
- 9. The radius of influence is
Options- A. radius of the main well
- B. distance from the wall of main well to the point of zero draw down
- C. distance from the centre of main well to the point of zero draw down
- D. none of these. Discuss
- 10. The initial setting time of lime-pozzolana, is
Options- A. 30 minutes
- B. 60 minutes
- C. 90 minutes
- D. 120 minutes. Discuss
More questions
Correct Answer: 2 metres/sec
Correct Answer: in the 0.4 to 0.8 ?m wave length region
Correct Answer: 1/3 to 1/2
Correct Answer: 0.65
Correct Answer: stop
Correct Answer:
Correct Answer: glazed bricks sewers
Correct Answer: differential gradient
Correct Answer: distance from the centre of main well to the point of zero draw down
Correct Answer: 120 minutes.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.