Discussion
Home ‣ Civil Engineering ‣ Strength of Materials Comments
- Question
The bending moment is maximum on a section where shearing force
Options- A. is maximum
- B. is minimum
- C. is equal
- D. changes sign.
- Correct Answer
- changes sign.
- 1. Every material obeys the Hooke's law within its
Options- A. elastic limit
- B. plastic point
- C. limit of proportionality
- D. none of these. Discuss
- 2. As the elastic limit reaches, tensile strain
Options- A. increases more rapidly
- B. decreases more rapidly
- C. increases in proportion to the stress
- D. decreases in proportion to the stress. Discuss
- 3. If a steel rod of 20 mm diameter and 5 metres long elongates by 2.275 mm when subjected to an axial pull of 3000 kg, the stress developed, is
Options- A. 9.5541 kg/cm2
- B. 95.541 kg/cm2
- C. 955.41 kg/cm2
- D. 9554.1 kg/cm2. Discuss
- 4. The distance between the centres of adjacent rivets in the same row, is called
Options- A. pitch
- B. lap
- C. gauge
- D. staggered pitch. Discuss
- 5. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is
Options- A. middle half rule of columns
- B. middle third rule of columns
- C. middle fourth rule of columns
- D. none of these. Discuss
- 6. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by
Options- A. 2 times
- B. 4 times
- C. 8 times
- D. 1/2 times
- E. 3 times. Discuss
- 7. If the stress produced by a prismatic bar is equal to the working stress, the area of the cross-section of the prismatic bar, becomes
Options- A. zero
- B. infinite
- C. maximum
- D. minimum. Discuss
- 8. The following assumption is not true in the theory of pure torsion :
Options- A. The twist along the shaft is uniform
- B. The shaft is of uniform circular section throughout
- C. Cross-section of the shaft, which is plane before twist remains plane after twist
- D. All radii get twisted due to torsion. Discuss
- 9. Pick up the correct statement from the following :
Options- A. The rate of change of bending moment is equal to rate of shear force
- B. The rate of change of shear force is equal to rate of loading
- C. neither (a) nor (b)
- D. both (a) and (b). Discuss
- 10. If the beam is supported so that there are only three unknown reactive elements at the supports. These can be determined by using the following fundamental equation of statics
Options- A. ?H = 0
- B. ?V = 0
- C. ?H = 0; ?H = 0
- D. ?H = 0; ?V = 0; ?M = 0
- E. ?M = 0; ?H = 0 Discuss
Strength of Materials problems
Search Results
Correct Answer: limit of proportionality
Correct Answer: increases more rapidly
Correct Answer: 955.41 kg/cm2
Correct Answer: pitch
Correct Answer: middle fourth rule of columns
Correct Answer: 8 times
Correct Answer: infinite
Correct Answer: All radii get twisted due to torsion.
Correct Answer: both (a) and (b).
Correct Answer: ?H = 0; ?V = 0; ?M = 0
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.