logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • Every material obeys the Hooke's law within its


  • Options
  • A. elastic limit
  • B. plastic point
  • C. limit of proportionality
  • D. none of these.

  • Correct Answer
  • limit of proportionality 


  • Strength of Materials problems


    Search Results


    • 1. As the elastic limit reaches, tensile strain

    • Options
    • A. increases more rapidly
    • B. decreases more rapidly
    • C. increases in proportion to the stress
    • D. decreases in proportion to the stress.
    • Discuss
    • 2. If a steel rod of 20 mm diameter and 5 metres long elongates by 2.275 mm when subjected to an axial pull of 3000 kg, the stress developed, is

    • Options
    • A. 9.5541 kg/cm2
    • B. 95.541 kg/cm2
    • C. 955.41 kg/cm2
    • D. 9554.1 kg/cm2.
    • Discuss
    • 3. The distance between the centres of adjacent rivets in the same row, is called

    • Options
    • A. pitch
    • B. lap
    • C. gauge
    • D. staggered pitch.
    • Discuss
    • 4. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is

    • Options
    • A. middle half rule of columns
    • B. middle third rule of columns
    • C. middle fourth rule of columns
    • D. none of these.
    • Discuss
    • 5. The neutral axis of a beam cross-section must

    • Options
    • A. pass through the centroid of the section
    • B. be equidistant from the top of bottom films
    • C. be an axis of symmetry of the section
    • D. none of these.
    • Discuss
    • 6. The bending moment is maximum on a section where shearing force

    • Options
    • A. is maximum
    • B. is minimum
    • C. is equal
    • D. changes sign.
    • Discuss
    • 7. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by

    • Options
    • A. 2 times
    • B. 4 times
    • C. 8 times
    • D. 1/2 times
    • E. 3 times.
    • Discuss
    • 8. If the stress produced by a prismatic bar is equal to the working stress, the area of the cross-section of the prismatic bar, becomes

    • Options
    • A. zero
    • B. infinite
    • C. maximum
    • D. minimum.
    • Discuss
    • 9. The following assumption is not true in the theory of pure torsion :

    • Options
    • A. The twist along the shaft is uniform
    • B. The shaft is of uniform circular section throughout
    • C. Cross-section of the shaft, which is plane before twist remains plane after twist
    • D. All radii get twisted due to torsion.
    • Discuss
    • 10. Pick up the correct statement from the following :

    • Options
    • A. The rate of change of bending moment is equal to rate of shear force
    • B. The rate of change of shear force is equal to rate of loading
    • C. neither (a) nor (b)
    • D. both (a) and (b).
    • Discuss


    Comments

    There are no comments.

Enter a new Comment