logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • The B.M. of a cantilever beam shown in below figure at A, is
    The B.M. of a cantilever beam shown in below figure at A, is zero 8 Tm 12 Tm 20 Tm.


  • Options
  • A. zero
  • B. 8 Tm
  • C. 12 Tm
  • D. 20 Tm.

  • Correct Answer
  • zero 


  • Strength of Materials problems


    Search Results


    • 1. For structural analysis, Maxwell's reciprocal theorem can be applied to :

    • Options
    • A. plastic structures
    • B. elastic structures
    • C. symmetrical structures
    • D. all the above.
    • Discuss
    • 2. According to Unwin's formula, the diameter d of a rivet of plate of thickness t is :

    • Options
    • A. d = 6.05 t
    • B. d = 1.5 t + 4
    • C. d = 5 t
    • D. d = t + 1.5
    • Discuss
    • 3. The materials which have the same elastic properties in all directions, are called

    • Options
    • A. isotropic
    • B. brittle
    • C. homogeneous
    • D. hard.
    • Discuss
    • 4. n and j are numbers of members and joints in a frame. It contains redundant members if

    • Options
    • A. n = 2j - 3
    • B. n = 3j - 2
    • C. n < 2j - 3
    • D. n < j - 2
    • E. n > 2j - 3
    • Discuss
    • 5. The number of points of contraflexure in a simple supported beam carrying uniformly distributed load, is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 0
    • Discuss
    • 6. For a channel section, the shear centre lies at a distance of

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 7. Pick up the correct statement from the following :

    • Options
    • A. A ductile material has large plastic zone
    • B. A brittle material has no plastic zone
    • C. A rigid material has no plastic zone
    • D. All the above.
    • Discuss
    • 8. Pick up the correct statement from the following :

    • Options
    • A. The point through which the resultant of the shear stresses, passes is known as shear centre
    • B. In the standard rolled channels, the shear centre is on the horizontal line passing through and away from the C.G. beyond web
    • C. In equal angles, the shear centre is on the horizontal plane and away from the C.G., outside of the leg projection
    • D. In T-sections, the shear centre is at the C.G. of the section
    • E. All the above.
    • Discuss
    • 9. During a tensile test on a ductile material

    • Options
    • A. nominal stress at fracture is higher than the ultimate stress
    • B. true stress at fracture is higher than the ultimate stress
    • C. true stress at fracture is the same as the ultimate stress
    • D. none of these.
    • Discuss
    • 10. If the stress in each cross-section of a pillar is equal to its working stress, it is called

    • Options
    • A. body of equal
    • B. body of equal section
    • C. body of equal strength
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment