logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • n and j are numbers of members and joints in a frame. It contains redundant members if


  • Options
  • A. n = 2j - 3
  • B. n = 3j - 2
  • C. n < 2j - 3
  • D. n < j - 2
  • E. n > 2j - 3

  • Correct Answer
  • n > 2j - 3 


  • Strength of Materials problems


    Search Results


    • 1. The number of points of contraflexure in a simple supported beam carrying uniformly distributed load, is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 0
    • Discuss
    • 2. An arch may be subjected to

    • Options
    • A. shear and axial force
    • B. bending moment and shear force
    • C. bending moment and axial force
    • D. shear force and thrust
    • E. thrust, shear force and bending moment.
    • Discuss
    • 3. While testing a cast iron beam (2.5 cm x 2.5 cm) in section and a metre long simply supported at the ends failed when a 100 kg weight is applied at the centre. The maximum stress induced is :

    • Options
    • A. 960 kg/cm2
    • B. 980 kg/cm2
    • C. 1000 kg/cm2
    • D. 1200 kg/cm2.
    • Discuss
    • 4. The maximum resistance against rotation, is offered by the weld at a point

    • Options
    • A. most distant
    • B. least distant
    • C. at either end
    • D. centrally located.
    • Discuss
    • 5. The maximum bending moment due to a moving load on a simply supported beam, occurs

    • Options
    • A. at the mid span
    • B. at the supports
    • C. under the load
    • D. anywhere on the beam
    • E. none of these.
    • Discuss
    • 6. The materials which have the same elastic properties in all directions, are called

    • Options
    • A. isotropic
    • B. brittle
    • C. homogeneous
    • D. hard.
    • Discuss
    • 7. According to Unwin's formula, the diameter d of a rivet of plate of thickness t is :

    • Options
    • A. d = 6.05 t
    • B. d = 1.5 t + 4
    • C. d = 5 t
    • D. d = t + 1.5
    • Discuss
    • 8. For structural analysis, Maxwell's reciprocal theorem can be applied to :

    • Options
    • A. plastic structures
    • B. elastic structures
    • C. symmetrical structures
    • D. all the above.
    • Discuss
    • 9. The B.M. of a cantilever beam shown in below figure at A, is

    • Options
    • A. zero
    • B. 8 Tm
    • C. 12 Tm
    • D. 20 Tm.
    • Discuss
    • 10. For a channel section, the shear centre lies at a distance of

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment