Discussion
Home ‣ Civil Engineering ‣ Strength of Materials Comments
- Question
The maximum bending moment due to a moving load on a simply supported beam, occurs
Options- A. at the mid span
- B. at the supports
- C. under the load
- D. anywhere on the beam
- E. none of these.
- Correct Answer
- under the load
- 1. In a three hinged arch, the shear force is usually
Options- A. maximum at crown
- B. maximum at springings
- C. maximum at quarter points
- D. varies with slope. Discuss
- 2. In a three hinged arch, the third hinge is generally kept at
Options- A. crown of the arch
- B. midpoint of the crown and left support hinge
- C. midpoint of the crown and right support hinge
- D. none of these. Discuss
- 3. If a three hinged parabolic arch carries a uniformly distributed load on its entire span, every section of the arch resists.
Options- A. compressive force
- B. tensile force
- C. shear force
- D. bending moment. Discuss
- 4. An arch with three hinges, is a structure
Options- A. statically determinate
- B. statically indeterminate
- C. geometrically unstable
- D. structurally sound but indeterminate
- E. none of these. Discuss
- 5. The structure shown in below figure is stable, if
Options- A.
- B. x = 2y
- C. x = y
- D. 2x = y. Discuss
- 6. The maximum resistance against rotation, is offered by the weld at a point
Options- A. most distant
- B. least distant
- C. at either end
- D. centrally located. Discuss
- 7. While testing a cast iron beam (2.5 cm x 2.5 cm) in section and a metre long simply supported at the ends failed when a 100 kg weight is applied at the centre. The maximum stress induced is :
Options- A. 960 kg/cm2
- B. 980 kg/cm2
- C. 1000 kg/cm2
- D. 1200 kg/cm2. Discuss
- 8. An arch may be subjected to
Options- A. shear and axial force
- B. bending moment and shear force
- C. bending moment and axial force
- D. shear force and thrust
- E. thrust, shear force and bending moment. Discuss
- 9. The number of points of contraflexure in a simple supported beam carrying uniformly distributed load, is
Options- A. 1
- B. 2
- C. 3
- D. 0 Discuss
- 10. n and j are numbers of members and joints in a frame. It contains redundant members if
Options- A. n = 2j - 3
- B. n = 3j - 2
- C. n < 2j - 3
- D. n < j - 2
- E. n > 2j - 3 Discuss
Strength of Materials problems
Search Results
Correct Answer: maximum at springings
Correct Answer: crown of the arch
Correct Answer: compressive force
Correct Answer: statically determinate
Correct Answer: 2x = y.
Correct Answer: most distant
Correct Answer: 960 kg/cm2
Correct Answer: thrust, shear force and bending moment.
Correct Answer: 0
Correct Answer: n > 2j - 3
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.