logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • The type of butt joints in common use, is :


  • Options
  • A. single inverted V-butt joint
  • B. double V-butt joint
  • C. double U-butt joint
  • D. single V-butt joint.

  • Correct Answer
  • single inverted V-butt joint 


  • Strength of Materials problems


    Search Results


    • 1. A bending moment may be defined as :

    • Options
    • A. Arithmetic sum of the moments of all the forces on either side of the section
    • B. Arithmetic sum of the forces on either side of the section
    • C. Algebraic sum of the moments of all the forces on either side of the section
    • D. None of these.
    • Discuss
    • 2. The length of a column, having a uniform circular cross-section of 7.5 cm diameter and whose ends are hinged, is 5 m. If the value of E for the material is 2100 tonnes/cm2, the permissible maximum crippling load will be

    • Options
    • A. 1.288 tonnes
    • B. 12.88
    • C. 128.8 tonnes
    • D. 288.0
    • E. none of these.
    • Discuss
    • 3. The length of a column which gives the same value of buckling load by Euler and Rankine-Gordon formula, is equal to

    • Options
    • A.
    • B.
    • C.
    • D. none of these.
    • Discuss
    • 4. If a shaft is simultaneously subjected to a toque T and a bending moment M, the ratio of maximum bending stress and maximum shearing stress is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 5. The reaction at support A of the beam shown in below figure, is

    • Options
    • A. zero
    • B. 5 T
    • C. 10 T
    • D. 1 T
    • E. 4 T.
    • Discuss
    • 6. The structure shown in below figure is stable, if

    • Options
    • A.
    • B. x = 2y
    • C. x = y
    • D. 2x = y.
    • Discuss
    • 7. An arch with three hinges, is a structure

    • Options
    • A. statically determinate
    • B. statically indeterminate
    • C. geometrically unstable
    • D. structurally sound but indeterminate
    • E. none of these.
    • Discuss
    • 8. If a three hinged parabolic arch carries a uniformly distributed load on its entire span, every section of the arch resists.

    • Options
    • A. compressive force
    • B. tensile force
    • C. shear force
    • D. bending moment.
    • Discuss
    • 9. In a three hinged arch, the third hinge is generally kept at

    • Options
    • A. crown of the arch
    • B. midpoint of the crown and left support hinge
    • C. midpoint of the crown and right support hinge
    • D. none of these.
    • Discuss
    • 10. In a three hinged arch, the shear force is usually

    • Options
    • A. maximum at crown
    • B. maximum at springings
    • C. maximum at quarter points
    • D. varies with slope.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment