CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Civil Engineering
‣
Concrete Technology
Comments
Question
Separation of water or water sand cement from a freshly concrete, is known
Options
A. bleeding
B. creeping
C. segregation
D. flooding
E. none of these.
Correct Answer
bleeding
Concrete Technology problems
Search Results
1. To obtain a very high strength concrete, use very fine grained
Options
A. Granite
B. Magnetite
C. Barite
D. Volcanic scoria.
Show Answer
Scratch Pad
Discuss
Correct Answer: Granite
2. Pick up the incorrect statemnt from the following. For performing compressive strength test of cement
Options
A. cement and standard sand mortar are used in the ratio of 1 : 3
B. water is added at the rate of
+ 3.0 percentage of water where
P
is the percentage of water for standard consistency
C. A cube mould of 10 cm x 10 cm x 10 cm is used
D. The perpared moulds are kept in a atmosphere of 50% relative humidity
E. The temperature of water in the submerged tank for curing moulds, should be 27° ± 2°C.
Show Answer
Scratch Pad
Discuss
Correct Answer: cement and standard sand mortar are used in the ratio of 1 : 3
3. To hydrate 500kg of cement full water needed, is
Options
A. 100 kg
B. 110 kg
C. 120 kg
D. 130 kg
E. 140 kg
Show Answer
Scratch Pad
Discuss
Correct Answer: 130 kg
4. The factor which affects workability, is
Options
A. water content and its temperature
B. shape and size of the aggregates
C. grading and surface textures of the aggregates
D. air entraining agents
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
5. According to Water-Cement Ratio Law, the strength of workable plastic concrete
Options
A. depends upon the amount of water used in the mix
B. does not depend upon the quality of cement mixed with aggregates
C. does not depend upon the quanity of cement mixed with aggregates
D. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
6. An ordinary Portland cement when tested for its fineness, should not leave any residue on I.S. seive No. 9, more than
Options
A. 5%
B. 10%
C. 15%
D. 20%
E. 25%
Show Answer
Scratch Pad
Discuss
Correct Answer: 10%
7. Workability of concrete mix with low water cement ratio is determined by
Options
A. tensile strength test
B. slump test
C. compaction factor test
D. flexural strength test
E. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: compaction factor test
8. Water cement ratio is
Options
A. volume of water to that of cement
B. weight of water to that of cement
C. weight of concrete to that of water
D. volume of concrete to that of water
E. both (a) and (b) of the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: both (a) and (b) of the above.
9. For the construction of cement con-certe dams, the maximum permissible size of the aggregates, is
Options
A. 40 mm
B. 50 mm
C. 60 mm
D. 70 mm
E. 80 mm
Show Answer
Scratch Pad
Discuss
Correct Answer: 40 mm
10. Permissible compressive strength of M 150 concrete grade is
Options
A. 100 kg/cm
2
B. 150 kg/cm
2
C. 200 kg/cm
2
D. 250 kg/cm
2
E. 300 kg/cm
2
Show Answer
Scratch Pad
Discuss
Correct Answer: 150 kg/cm
2
Comments
There are no comments.
Enter a new Comment
Save
More in Civil Engineering:
Advanced Surveying
Airport Engineering
Applied Mechanics
Building Construction
Building Materials
Concrete Technology
Construction Management
Docks and Harbours
Elements of Remote Sensing
Engineering Economy
Estimating and Costing
GATE Exam Questions
Highway Engineering
Hydraulics
Irrigation
Railways
RCC Structures Design
SI Units
Soil Mechanics and Foundation Engineering
Steel Structure Design
Strength of Materials
Structural Design Specifications
Surveying
Theory of Structures
Tunnelling
UPSC Civil Service Exam Questions
Waste Water Engineering
Water Resources Engineering
Water Supply Engineering